Nortel Networks 4070 quick start Configuration, Creating a new cluster, Prerequisites

33

Configuration

This chapter contains configuration instructions for commissioning the Nortel Secure Network Access Switch.

Navigation

•"Creating a new cluster" (page 33)

•"Joining an SNAS to an existing cluster" (page 36)

•"Enabling the browser-based interface" (page 38)

•"Applying the Nortel SNAS license" (page 40)

Creating a new cluster

This section describes how to create a new cluster.

Nortel Secure Network Access Switch (Nortel SNAS) is member of a cluster. A cluster can consist of a single unit of a group of units that share the same configuration parameters. There can be more than one cluster in the network, each with its own set of parameters and services.

Establish a console connection by cabling the unit to a terminal or a computer running a terminal emulator session.

Prerequisites

•Establish a console connection by cabling the unit to a terminal or a computer running a terminal emulator session.

Procedure steps

Step Action

1Using the supplied console cable, connect the terminal to the console port.

2Power on the terminal and the Nortel Secure Network Access Switch 4070.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks