Nortel Networks 4070 quick start Trademarks

Page 11

Trademarks 11

CAUTION

To reduce the risk of ﬁre, use only number 26 AWG or larger UL Listed or CSA Certiﬁed Telecommunication Line Cord for all network connections.

WARNING

Before working on this equipment be aware of good safety practices and the hazards involved with electrical circuits.

Trademarks

*Nortel, Nortel Networks, the Nortel logo, and the Globemark are trademarks of Nortel Networks.

Adobe and Adobe Reader are trademarks of Adobe Systems Incorporated.

Microsoft, Windows, and Windows NT are trademarks of Microsoft

Corporation.

The asterisk after a name denotes a trademarked item.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 11

Contents Installation Quick Start Switch Legal Notice Contents Installation International Regulatory Statements of Conformity Regulatory Information and Safety PrecautionsEN 55024 statement Ices statement Canada onlyCE marking statement Europe only EN 55022 statementNOM statement Mexico only National Safety Statements of Compliance EN 60950 statementVcci statement Japan/Nippon only MIC notice Republic of Korea onlyInformación NOM unicamente para México Denan statement Japan/Nippon onlyWeee Directive Compliance Statement National Environmental Statements of ComplianceRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Nortel Networks software license agreement Software licenseGeneral Nortel Networks software license agreement Software license Other changes FeaturesNew in this release New in this release Navigation IntroductionPrerequisites Introduction Personal safety before installing the device Installation preparationSafety precautions Safety precautions navigationCable and connector safety Procedure steps Installation checklistInstallation preparation Unpacking the device InstallationPrerequisites for installing an Nsna into a rack Installing an Nsna device into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Cabling the device navigation Connecting network cablesConnecting serial cables Cabling the deviceSerial connection parameters Parameter Value Installation Prerequisites ConﬁgurationCreating a new cluster Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Endpoints Applying the Nortel Snas licenseThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch