Nortel Networks 4070 quick start Installing an Nsna device into a rack

Page 27

Installing an NSNA device into a rack 27

2Align the slide rail with the front mounting ﬂange by aligning the score mark on the slide rail (1) with the score mark on the rail between the upper and lower U. Push outward on the slide rail latch to close to the latch and secure the slide rail. Do the same for the other front of the slide rail. Align the slide rail with the rear mounting ﬂange and close the latches for the rear of the slide rail to secure it.

Ensure the slide rails are securely seated on the mounting ﬂanges. When the slide rail are secure, the slide rail pins protrude from the slide rails (2).

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 27

Contents Installation Quick Start Switch Legal Notice Contents Installation International Regulatory Statements of Conformity Regulatory Information and Safety PrecautionsEN 55024 statement Ices statement Canada onlyCE marking statement Europe only EN 55022 statementNOM statement Mexico only National Safety Statements of Compliance EN 60950 statementVcci statement Japan/Nippon only MIC notice Republic of Korea onlyInformación NOM unicamente para México Denan statement Japan/Nippon onlyWeee Directive Compliance Statement National Environmental Statements of ComplianceRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Nortel Networks software license agreement Software licenseGeneral Nortel Networks software license agreement Software license Features New in this releaseOther changes New in this release Introduction PrerequisitesNavigation Introduction Personal safety before installing the device Installation preparationSafety precautions Safety precautions navigationCable and connector safety Procedure steps Installation checklistInstallation preparation Unpacking the device InstallationPrerequisites for installing an Nsna into a rack Installing an Nsna device into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Cabling the device navigation Connecting network cablesConnecting serial cables Cabling the deviceSerial connection parameters Parameter Value Installation Conﬁguration Creating a new clusterPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Endpoints Applying the Nortel Snas licenseThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch