Nortel Networks 4070 quick start Enabling the browser-based interface

Page 38

38Configuration

6Enter the Management IP address (MIP) of the existing cluster.

Provide the Management IP address of the cluster to which you want to join the new SNAS. To check the Management IP of an existing cluster, connect to the cluster and use the /cfg/sys/cur command.

7Provide the correct admin user password.

—End—

The SNAS that is joined to the cluster automatically picks up all configuration data from an installed SNAS in the cluster.

Wait until the Setup utility gets finished.

The login prompt appears.

Log in as admin to continue to configure the SNAS cluster using the CLI or the BBI.

Enabling the browser-based interface

The SNAS browser-based interface (BBI) is not immediately available for use when the device is first commissioned. The BBI can be enabled to work over HTTP, HTTPS, or both protocols. It is recommended the default ports of 80 (HTTP) and 4443 (HTTPS) be changed when it comes to device management. HTTP and HTTPS client traffic is connected through these default ports and if used in device management cannot be available to service requests.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 38
Contents Installation Quick Start Switch Legal Notice Contents Installation Regulatory Information and Safety Precautions International Regulatory Statements of ConformityEN 55022 statement Ices statement Canada onlyCE marking statement Europe only EN 55024 statementMIC notice Republic of Korea only National Safety Statements of Compliance EN 60950 statementVcci statement Japan/Nippon only NOM statement Mexico onlyDenan statement Japan/Nippon only Información NOM unicamente para MéxicoNational Environmental Statements of Compliance Weee Directive Compliance StatementRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Software license Nortel Networks software license agreementGeneral Nortel Networks software license agreement Software license Other changes FeaturesNew in this release New in this release Navigation IntroductionPrerequisites Introduction Safety precautions navigation Installation preparationSafety precautions Personal safety before installing the deviceCable and connector safety Installation checklist Procedure stepsInstallation preparation Installation Unpacking the deviceInstalling an Nsna device into a rack Prerequisites for installing an Nsna into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Cabling the device Connecting network cablesConnecting serial cables Cabling the device navigationSerial connection parameters Parameter Value Installation Prerequisites ConfigurationCreating a new cluster Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Applying the Nortel Snas license EndpointsThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch