Nortel Networks 4070 quick start

Contents Installation Quick Start Switch Legal Notice Contents Installation International Regulatory Statements of Conformity Regulatory Information and Safety PrecautionsEN 55024 statement Ices statement Canada onlyCE marking statement Europe only EN 55022 statementNOM statement Mexico only National Safety Statements of Compliance EN 60950 statementVcci statement Japan/Nippon only MIC notice Republic of Korea onlyInformación NOM unicamente para México Denan statement Japan/Nippon onlyWeee Directive Compliance Statement National Environmental Statements of ComplianceRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Nortel Networks software license agreement Software licenseGeneral Nortel Networks software license agreement Software license New in this release FeaturesOther changes New in this release Prerequisites IntroductionNavigation Introduction Personal safety before installing the device Installation preparationSafety precautions Safety precautions navigationCable and connector safety Procedure steps Installation checklistInstallation preparation Unpacking the device InstallationPrerequisites for installing an Nsna into a rack Installing an Nsna device into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Cabling the device navigation Connecting network cablesConnecting serial cables Cabling the deviceSerial connection parameters Parameter Value Installation Creating a new cluster ConfigurationPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Endpoints Applying the Nortel Snas licenseThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch