Nortel Networks 4070 quick start Installation, Unpacking the device

Page 25

25

Installation

This chapter contains installation instructions for the Nortel Secure Network Access Switch (NSNA).

Navigation

"Unpacking the device" (page 25)

"Installing an NSNA device into a rack" (page 26)

"Cabling the device" (page 30)

Unpacking the device

Unpack the shipping container to ensure the device and all accessories are included and undamaged.

Procedure steps

Step Action

1Remove the equipment from the shipping container and place the device on antistatic material.

2Check all items for damage.

ATTENTION

If the equipment is damaged, contact your Nortel sales representative.

3Use the following device shipping accessories checklist to verify that in the shipping container includes all contents.

Check

 

Accessory

Use to

 

 

 

 

 

 

Switch

Install in a 4 post server rack.

 

 

 

 

 

 

Power units

Connect the units to an

 

 

 

appropriate and properly

 

 

 

grounded power source.

 

 

 

 

 

 

Network cables

Connect the device.

 

 

 

Nortel Secure Network Access

 

Installation — Quick Start Switch 4070

 

NN47230-303 01.01 Standard

 

2.0

28 July 2008

 

Copyright © 2008, Nortel Networks

Image 25
Contents Installation Quick Start Switch Legal Notice Contents Installation International Regulatory Statements of Conformity Regulatory Information and Safety PrecautionsCE marking statement Europe only Ices statement Canada onlyEN 55022 statement EN 55024 statementVcci statement Japan/Nippon only National Safety Statements of Compliance EN 60950 statementMIC notice Republic of Korea only NOM statement Mexico onlyInformación NOM unicamente para México Denan statement Japan/Nippon onlyWeee Directive Compliance Statement National Environmental Statements of ComplianceRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Nortel Networks software license agreement Software licenseGeneral Nortel Networks software license agreement Software license New in this release FeaturesOther changes New in this release Prerequisites IntroductionNavigation Introduction Safety precautions Installation preparationSafety precautions navigation Personal safety before installing the deviceCable and connector safety Procedure steps Installation checklistInstallation preparation Unpacking the device InstallationPrerequisites for installing an Nsna into a rack Installing an Nsna device into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Connecting serial cables Connecting network cablesCabling the device Cabling the device navigationSerial connection parameters Parameter Value Installation Creating a new cluster ConfigurationPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Endpoints Applying the Nortel Snas licenseThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch