Nortel Networks 4070 quick start Installation

Page 4

4Contents

Safety precautions

21

Safety precautions navigation 21

Installation checklist

23

Installation

25

Navigation 25

 

Unpacking the device 25

 

Installing an NSNA device into a rack 26

 

Prerequisites for installing an NSNA into a rack

26

Cabling the device 30

 

Cabling the device navigation 30

 

Connecting network cables 30

 

Connecting serial cables 30

 

Configuration

33

Navigation 33

 

Creating a new cluster 33

 

Prerequisites 33

 

Joining an SNAS to an existing cluster

36

Enabling the browser-based interface

38

Applying the Nortel SNAS license 40

 

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 4
Contents Installation Quick Start Switch Legal Notice Contents Installation Regulatory Information and Safety Precautions International Regulatory Statements of ConformityIces statement Canada only CE marking statement Europe onlyEN 55022 statement EN 55024 statementNational Safety Statements of Compliance EN 60950 statement Vcci statement Japan/Nippon onlyMIC notice Republic of Korea only NOM statement Mexico onlyDenan statement Japan/Nippon only Información NOM unicamente para MéxicoNational Environmental Statements of Compliance Weee Directive Compliance StatementRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Software license Nortel Networks software license agreementGeneral Nortel Networks software license agreement Software license New in this release FeaturesOther changes New in this release Prerequisites IntroductionNavigation Introduction Installation preparation Safety precautionsSafety precautions navigation Personal safety before installing the deviceCable and connector safety Installation checklist Procedure stepsInstallation preparation Installation Unpacking the deviceInstalling an Nsna device into a rack Prerequisites for installing an Nsna into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Connecting network cables Connecting serial cablesCabling the device Cabling the device navigationSerial connection parameters Parameter Value Installation Creating a new cluster ConfigurationPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Applying the Nortel Snas license EndpointsThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch