Nortel Networks 4070 quick start Applying the Nortel Snas license, Endpoints

Page 40

40Configuration

>> Administrative Applications# https

9(Optional) From the HTTPS access menu, designate a port for HTTPS access using the port command.

>>HTTPS# port <port_number>

Using a port other than 4443 requires the user to designate the port when accessing the BBI. For example, if the device IP address is 192.168.0.3 and the designated port is 465, the device is accessed from the browser as: https://192.168.0.3:465.

10(Optional) From the HTTPS access menu, enable BBI access using the ena command.

>>HTTPS# ena

11(Optional) Finalize the changes using the apply command.

>>HTTPS# apply

—End—

Applying the Nortel SNAS license

 

The Nortel SNAS ships with support for up to 200 authenticated user

 

sessions. To support additional users on your Nortel SNAS switch, you must

 

obtain a Nortel SNA software license file. The software license file contains

 

a software license key that you must enter into the Nortel SNAS switch to

 

activate support for the additional users. The file can support an additional

 

100, 250, 500, 1000, 2000, or, 5000 users.

 

The following table lists the part number for the additional concurrent

 

endpoints.

 

 

 

Part Number

 

Description

 

 

 

EB1639171

 

Secure Network Access License - Add 100 concurrent

 

 

endpoints

 

 

 

EB1639172

 

Secure Network Access License - Add 250 concurrent

 

 

endpoints

 

 

 

EB1639175

 

Secure Network Access License - Add 500 concurrent

 

 

endpoints

 

 

 

EB1639182

 

Secure Network Access License - Add 1000 concurrent

 

 

endpoints

 

 

 

 

Nortel Secure Network Access

 

Installation — Quick Start Switch 4070

 

NN47230-303 01.01 Standard

 

 

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 40
Contents Installation Quick Start Switch Legal Notice Contents Installation Regulatory Information and Safety Precautions International Regulatory Statements of ConformityIces statement Canada only CE marking statement Europe onlyEN 55022 statement EN 55024 statementNational Safety Statements of Compliance EN 60950 statement Vcci statement Japan/Nippon onlyMIC notice Republic of Korea only NOM statement Mexico onlyDenan statement Japan/Nippon only Información NOM unicamente para MéxicoNational Environmental Statements of Compliance Weee Directive Compliance StatementRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Software license Nortel Networks software license agreementGeneral Nortel Networks software license agreement Software license New in this release FeaturesOther changes New in this release Prerequisites IntroductionNavigation Introduction Installation preparation Safety precautionsSafety precautions navigation Personal safety before installing the deviceCable and connector safety Installation checklist Procedure stepsInstallation preparation Installation Unpacking the deviceInstalling an Nsna device into a rack Prerequisites for installing an Nsna into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Connecting network cables Connecting serial cablesCabling the device Cabling the device navigationSerial connection parameters Parameter Value Installation Creating a new cluster ConfigurationPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Applying the Nortel Snas license EndpointsThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch