Additional handsets
Up to 5 handsets can be registered and operated from the BT Graphite 2100 base.
If you buy new handsets to use with your BT Graphite 2100 they will have to be registered to the base before you can use them.
Register a new BT Graphite 2100 handset to your BT Graphite 2100 base
1. At the base: Press and hold | Find | for 5 seconds until you hear a |
beep. You now have 60 seconds to register the handset.
Menu
2. At the handset: press 
, scroll Calls to ADVANCED SET and press Menu .
3. If the handset has previously been registered to another base it will show REGISTRATION. If the handset has not previously been registered to a base it will show UNREGISTERED, press
Menu .
4. Enter the
5. The handset will be automatically assigned the first available handset number, e.g. 2, 3, 4 or 5. You will hear a beep.
The handset is now registered.
If registration does not work:
•Make sure there is no other electrical equipment very close by that may interfere with the registration signal.
•Make sure you do not already have 5 handsets registered to the base as the registration process will stop if you do.
•Try following steps 1-5 above again.
Register a different manufacturer’s handset to your BT Graphite 2100 base
1. At the base: Press and hold | Find | for 5 seconds until you hear |
|
|
continuous beeping. You now have 60 seconds to register the handset.
29
Handsets that were supplied with your BT Graphite 2100 base are already registered to it as HANDSET 1, HANDSET 2 etc.
Each additional handset you buy must be registered with the base.
IMPORTANT
Before registration, make sure the handset batteries are fully charged and that you are close to the base.
Cancel registration
Press Secrecy.
Naming additional handsets
Once you have registered additional handsets you may wish to give them a different name, see page 21.
IMPORTANT
DECT GAP Profile only guarantees that basic
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp