Panasonic KX-TG4381NZ, KX-TG4382NZ, KX-TG4392NZ Charger, To remove the wall mounting adaptor

Page 42

Useful Information

5Connect the telephone line cord. Drive the screws (not included) into the wall. Mount the unit, and then slide it down. Connect the AC adaptor to power outlet (page 12).

(220–240V AC, 50/60 Hz)

Screws

83 mm

To single-line telephone socket

To remove the wall mounting adaptor

While pushing down the release levers (A), remove the adaptor (B).

A A

Charger

Available for:

KX-TG4382/KX-TG4392

1Drive the screws (not included) into the wall.

25.4mm

Screws

(220–240 V AC,

50/60 Hz)

2Mount the charger (A), then slide it down (B) and to the right (C) until it is secure.

Image 42

Contents Operating Instructions Introduction Caller ID ServiceVoice Mail Service PreparationProduct information Notable differences between the modelsFeature differences Model No Answering system Intercom Accessory information Supplied accessoriesReplacement battery information For your safety Battery General noticeRechargeable Ni-MH batteries AAA R03 size Important notice Important safety instructionsFor best performance Base unit location/avoiding noiseIntroduction Answer on indicator ControlsBase unit Navigator key /V// ? Volume /V HandsetDisplay ConnectionsCharger Battery installation and replacement Base unit Charger*1 Battery chargeBattery level Battery icon KX-TG4381/KX-TG4382Setting up the unit before use Date and timeBelt clip Headset optionalTo attach the belt clip To remove the belt clip Making calls Answering callsMute Useful features during a callHold RecallCall share Dial lockHandset clarity booster To turn dial lock onPhonebook Adding entriesFinding and calling a phonebook entry Chain dial Editing entriesErasing entries Erase iYes iOFFMenu Programmable settingsProgramming by scrolling through the display menus Main menu Sub-menuInitial setting Set answering Ring count*1 Programming using the direct commands Feature Setting code System Code Setting*1Access# Time Alarm Special instructions for programmable settingsNight mode Setting the start and end timeProgramming Using Caller ID service Caller ID featuresRinger ID Storing your area code Caller listViewing the caller list and calling back View CIDErasing all caller information Editing a caller’s phone number before calling backErasing selected caller information Storing caller information into the phonebookGreeting message Turning off the call screening featureAnswering system Memory capacityPlaying back the greeting message Using a pre-recorded greeting messageRecording your greeting message Erasing your greeting messageMenu Message play i Select Voice guidanceCalling back Caller ID subscribers only EraseRemote commands Remote access codeUsing the answering system remotely Remote operationAnswering system settings Turning on the answering system remotelyNumber of rings before the unit answers calls Caller’s recording time Message alertTo erase the voice mail access number Voice mail serviceStoring the voice mail VM access number Listening to voice mail messagesVoice Mail Service Answering an intercom call IntercomMaking an intercom call Handset KX-TG4382/KX-TG4391Handset locator Wall mounting To remove the wall mounting adaptor Error messages Display message Cause/solutionTroubleshooting General use Problem Cause/solutionProgrammable settings Problem Cause/solution Battery recharge Problem Cause/solution Problem Cause/solutionMaking/answering calls, intercom Caller ID Problem Cause/solution Answering system KX-TG4391/KX-TG4392 Problem Cause/solution KX-TG4381/KX-TG4391 Registration Problem Cause/solutionHandset Menu i#130 KX-TG4382/KX-TG4392Liquid damage Problem Cause/solution Specifications Index Sales Department PNQX1239ZA CM0708PF0For your future reference Copyright