Programming
Registering a unit
Registering a handset to the base unit
The supplied handset and base unit are
1Handset:
8(middle soft key)
2{V}/{^}: “Handset Setup” i
M
3{V}/{^}: “Register H.set” i
M
4Base unit:
Proceed with the operation for your model.
■
Press and hold {x} for about 5 seconds. (No registration tone)
■KX-TG6421
Press and hold {x} for about 5 seconds, until the registration tone sounds.
LIf all registered handset(s) start(s) ringing, press the same button to stop. Then repeat this step.
L The next step must be completed within 90 seconds.
5Handset:
Wait until “Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). i M
L If you forget your PIN, contact your nearest Panasonic service centre.
L When the handset has been registered successfully, w stops flashing.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system.
18(middle soft key)
2{V}/{^}: “Base Unit Setup” i
M
3{3}{3}{5}
4{V}/{^}: “Cancel Register” i
M
L The numbers of all handsets registered to the base unit are displayed.
5Select the handset(s) you want to cancel by pressing the desired handset number. i M
L The selected handset number(s) flashes.
L To cancel a selected handset number, press the number again. The number stops flashing.
6{V}/{^}: “Yes” i M
L A confirmation tone sounds as each handset number disappears.
L The handset does not beep when cancelling its own registration.
7{ih}
Increasing the range of the base unit
You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details.
23