Panasonic KX-TG6711FX Incoming call barring Caller ID, Subscribers only, Numbers

								Programming
3	Enter the desired hour and minute you
					Incoming call barring (Caller ID
	wish to start this feature. a
						subscribers only)
	R You can select 24-hour or 12-hour
	clock format (“AM” or “PM”) by					This feature allows the unit to reject calls from
	pressing		.			specified phone numbers that you do not want
4	Enter the desired hour and minute you					to answer such as junk calls.
						When a call is received, the unit does not ring
5	wish to end this feature. a					while the caller is being identified. If the phone
	M	N				number matches an entry in the call barred
	R When the night mode is set,			is		list, the unit sends out a busy tone to the
						caller, and then disconnects the call.
	displayed.
						Important:
Changing the start and end time						R When the unit receives a call from a
1		#237				number that is stored in the call barred list,
						the call is logged in the caller list
2	Continue from step 3, “Turning night					(page 31) with after the call is
	mode on/off”, page 26.					disconnected.
Setting the ring delay
						Storing unwanted callers
This setting allows the handset to ring during						You can store up to 30 phone numbers in the
night mode if the caller waits long enough.
						call barred list.
After the selected amount of time passes, the
						Important:
handset rings. If you select “No Ringing”,
						R You must store the phone number with an
the handset never rings during night mode.
1		#239				area code in the call barred list.
						n From the caller list:
2	MbN: Select the desired setting. a
					1		MFN (	)
	a M	N
						2 MbN: Select the entry to be barred. a
Changing the handset name					3		MbN: “Caller Barred” a
Each handset can be given a customised
					4		MbN: “Yes” a		a M	N
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between						n By entering phone numbers:
handsets. You can also select whether or not					1		#217 a
the handset name is displayed in standby						2 Enter the phone number (24 digits
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,							max.). a
“Handset 1” to “Handset 6” is displayed.					3		R To erase a digit, press			.
1		#104					M	N
2	Enter the desired name (max. 10
						Viewing/editing/erasing bar call
	characters; page 38).
3	R If not required, go to step 3.					numbers
					1		#217
4	MbN: Select the desired setting. a			2
						2 MbN: Select the desired entry.
	times
5						R To exit, press M			N.
	M	N

27

TG6711FX(en)_0130_ver002.pdf 27

2012/01/30 18:56:54