Panasonic KX-TG6711FX operating instructions Registering a unit, Operating additional units

Page 29

Programming

the handset momentarily. This is normal

and the handset can be used once is displayed.

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the base unit.

Important:

RThe additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc.) may not be available.

Registering a handset to the base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, is displayed even when the handset is near the base unit), re-register the handset.

1Handset:

#130

2Base unit:

Press and hold MN for about 5 seconds. (No registration tone)

R If all registered handsets start ringing, press MN again to stop, then repeat this step.

R The next step must be completed within 90 seconds.

3Handset:

a Wait until “Base PIN” is displayed. a Enter the base unit PIN

(default: “0000”). a

R If you forget your PIN, contact an authorised service centre.

R When the handset has been registered

successfully, is displayed.

Note:

R While registering, “Base in registering” is displayed on all registered handsets.

RWhen you purchase an additional handset, refer to the additional handset’s installation manual for registration.

Deregistering a handset

A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.

1#131

R All handsets registered to the base unit are displayed.

2MbN: Select the handset you want to cancel. a

3MbN: “Yes” a

R A confirmation tone sounds.

R The handset does not beep when cancelling its own registration.

4MN

Increasing the range of the base unit

You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 3. Contact your Panasonic dealer for details.

Important:

RBefore registering the repeater to this base unit, you must turn the repeater mode on.

RDo not use more than one repeater at a time.

Setting the repeater mode

1#138

2MbN: Select the desired setting. a

a MN

29

TG6711FX(en)_0130_ver002.pdf 29

2012/01/30 18:56:54

Image 29

Contents Thank you for purchasing a Panasonic product Digital Cordless PhoneTable of Contents Additional/replacement accessories Accessory informationSupplied accessories Expanding your phone system General informationFor your future reference Handset optional KX-TGA671FXFor your safety Battery Important safety instructionsFor best performance Base unit location/avoiding noiseFor business users in the European Union Other informationRoutine care RF transmission power SpecificationsStandard Frequency rangeBattery installation Setting upBattery charging ConnectionsOperation Operating time Battery levelIcon Battery level Base unit ControlsHandset Handset display items DisplayHandset soft key icons MeaningInitial settings Turning the power on/offDisplay language Date and timeDialling mode One touch eco modeUsing the smart function key Top Key Setting the smart function key Top Key SetupWall mounting Answering calls Making callsCall Useful features during aMbN Equalizer a 3 MbN Select the desired setting Power back-up operationKey lock Call shareWhen only 1 handset is registered Making calls during a power failureHandset phonebook Copying an entry Copying phonebook entriesCopying all entries MbN Copy All aDisplay the menu tree and direct command code table Programmable settingsPBX Access # *1 Off Send List Create Settings Message Centre1 *1, *3Ringer Setup Ringer Volume Night ModeTop Key Setup Display Setup LCD & Key BacklightLine Setup Dial Mode*1 Pulse Cancel Register*13Ring Delay 30 sec Night Mode On/OffStart/End 60 sec 90 sec 120 sec No Ringing First Ring *1, *7Night mode AlarmTurning night mode on/off Special programmingIncoming call barring Caller ID Setting the ring delay Storing unwanted callersSubscribers only Changing the handset nameChanging the unit’s region setting/Resetting the base unit Setting call restrictionChanging the base unit PIN Personal Identification Number Česká rep. = Czech Slovensko = SlovakiaOperating additional units Registering a unitRegistering a handset to the base unit Increasing the range of the base unitDect repeater Registering the Dect repeater KX-A405 to the base unitCaller ID features Using Caller ID serviceCaller list Viewing the caller list and calling backErasing selected caller information Editing a caller’s phone number before calling backErasing all caller information Storing caller information to the phonebookTurning SMS on/off Using SMSStoring SMS message centre numbers Sending a messageEditing/sending a saved message Receiving a messageErasing saved messages Reading a received messageOther settings New messages, is displayed on Voice mail serviceTransferring calls, conference calls IntercomHandset locator Character entry When the unit displays the character entry screenCharacter entry modes Alphabet character table ABCExtended 1 character table Greek character tableExtended 2 character table Not available for SMS Cyrillic character table Not available for SMSDisplay message Error messagesCause/solution Programmable settings TroubleshootingProblem General useMaking/answering calls, intercom Battery rechargeCaller ID SMS Short Message ServiceLiquid damage Index 2012/01/30 2012/01/30 Romania FX-2/3Sales Department Czech Slovakia