Panasonic KX-TG6442, KX-TG6431, KX-TG6445T Error messages, Display message Cause/solution

Page 44

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message

Cause/solution

Busy

L The called unit is in use.

or

L Other units are in use and the system is busy.

Try again later.

System busy. Try again

L The handset you are using is too far from the

base unit. Move closer and try again.

later.

L The handset’s registration may have been

 

canceled. Re-register the handset (page 27).

Check tel line

L The supplied telephone line cord has not been

 

connected yet or not connected properly.

 

Check the connections (page 9).

Use rechargeable

L A wrong type of battery such as Alkaline or

battery.

Manganese was inserted. Use only the

 

rechargeable Ni-MH batteries noted on page

 

5, 7.

Error!!

L The handset’s registration has failed. Move

 

the handset and base unit away from all

 

electrical appliances and try again.

Invalid

L There is no handset registered to the base

 

unit matching the handset number you

 

entered.

 

L The handset is not registered to the base unit.

 

Register the handset (page 27).

No link. Reconnect base

L The handset has lost communication with the

AC adaptor.

base unit. Move closer to the base unit and try

 

again.

 

L Unplug the base unit’s AC adaptor to reset the

 

unit. Reconnect the adaptor and try again.

 

L The handset’s registration may have been

 

canceled. Re-register the handset (page 27).

Requires subscription

L You must subscribe to a Caller ID service.

to Caller ID.

Once you receive caller information after

 

subscribing to a Caller ID service, this

 

message will not be displayed.

Store V.M. no.

L You have not stored the voice mail access

 

number. Store the number (page 37).

44For assistance, please visit http://www.panasonic.com/help

Image 44
Contents KX-TG6441 KX-TG6442KX-TG6443 KX-TG6444Caller ID Service Voice Mail ServiceIntroduction Important InformationModel composition KX-TG Accessory informationSupplied accessories Additional/replacement accessories Accessory item Order numberOptional handset feature overview Feature Expanding your phone systemFor your safety Important safety instructions Specifications Setting up Battery installationBattery charge ConnectionsOperation Operating time During a power failureBattery level Icon Base unit ControlsHandset KX-TGA641 Display Locator Intercom Answer onRedial Pause Hold Flash Call Wait MuteInitial settings Dialing modeDisplay language Voice guidance languageSP-PHONE Using the base unitRedial Answering calls Using the handsetAdjusting the base unit ringer volume Useful features during a call HoldMute FlashTemporary tone dialing for rotary/pulse service users Handset clarity boosterCall share Call WaitShared phonebook Adding entriesFinding and calling a phonebook entry SelectEditing entries Erasing entriesChain dial OFFProgrammable settings Programming by scrolling through the display menusMenu Main menu Sub-menuTalking CallerID Programming using the direct commands Feature Setting code System CodePre-recorded Time adjust*10 Silent mode AlarmSpecial programming SaveClear Call block Caller ID subscribers onlyADD Registering a handset to a base unit Registering a unitOperating additional units Using Caller ID service Caller ID featuresTalking Caller ID Missed callsCaller ID number auto edit feature Caller listRinger ID Viewing the caller list and calling backErasing selected caller information Erasing all caller informationStoring caller information to the phonebook Select iOFFAnswering system Turning the answering system on/offMemory capacity Call screeningListening to messages using the base unit Greeting messageListening to messages using the handset Erasing all messagesCalling back Caller ID subscribers only StopVoice memo Remote operationAnswering system settings Remote commandsWhen the Spanish voice guidance is selected Turning on the answering system remotelyMessage alert For voice mail service subscribersCaller’s recording time Voice mail service Storing the voice mail VM access numberTo erase the voice mail access number Voice mail VM tone detectionTurning VM tone detection on/off The default setting is On Listening to voice mail messagesIntercom Handset locatorMaking an intercom call Answering an intercom callTransferring calls, conference calls Handset 2 ReceiverTo establish a conference call Handset Handset Press CTo establish a conference call Base unit To attach Belt clipWall mounting Charger To remove the wall mounting adaptorError messages Display message Cause/solutionProgrammable settings Problem Cause/solution TroubleshootingGeneral use Problem Cause/solution Making/answering calls, intercom Problem Cause/solutionBattery recharge Problem Cause/solution Caller ID/Talking Caller ID Problem Cause/solution Answering system Problem Cause/solution Liquid damage Problem Cause/solution FCC and other information FCC RF Exposure Warning Guía Rápida Española Correcto IncorrectoIdioma de la guía de voz Teclas de funciónIdioma de la pantalla Operaciones básicas Para grabar su propio mensaje Mensaje marcador Contestador de llamadas Unidad basePreguntas frecuentes Solución rápida de problemas 1El auricular muestra2El auricular no emite ningún tono de marcación Hablar apareceCómo registrar un auricular a una unidad base TTY users hearing or speech impaired users can call Customer servicesOr, contact us via the web at Warranty For United States and Puerto Rico Ship-In ServicePanasonic Consumer Electronics Company Parts Labor One 1 YearLimited Warranty Limits And Exclusions Index Read these Operating Instructions Call us at 1-800-211-PANAFor your future reference Copyright