| Useful Information |
|
|
Problem | Cause/solution |
The STATUS indicator is off. | L The power of the base unit is off. |
| L You have not agreed to the Terms of Use for |
| the Aservices. To use the AIP line, you |
| need to agree to it using the handset (page |
| 18). |
| L The Ethernet cable is not connected properly. |
| Connect it. |
| L Your network devices (hub, router, etc.) are |
| turned off. Check the LEDs for the link status |
| of the devices. |
Programmable settings |
|
|
|
Problem | Cause/solution |
I cannot program items. | L Programming is not possible while either |
| another handset or the base unit is being |
| used. Try again later. |
| L Programming is not possible while the base |
| unit is downloading data from the A |
| service. Wait until the STATUS indicator stops |
| flashing and lights in steady green. |
While programming, the | L A call is being received. Answer the call and |
handset starts to ring. | start again after hanging up. |
Battery recharge |
|
|
|
Problem | Cause/solution |
I fully charged the battery, but | L Clean the charge contacts and charge again |
3continues to flash, or 4 | (page 20). |
is displayed. | L The battery may need to be replaced with new |
| ones (page 21). |
The handset display is blank. | L Confirm that the battery are properly installed. |
| L Fully charge the battery (page 20). |
For product assistance, visit www.panasonic.com/help | 83 |
For Aassistance, visit www.joip.com |
|