Uniden UH-099 owner manual Removing Group Scan Channels, Open Scanning

Removing Group Scan Channels

To Delete a programmed channel from the Group Scan Memory, use the following procedure:

1.Rotate the CHANNEL SELECTOR knob until the channel you wish to remove is displayed. Note that the MEM indicator should appear, indicating that this channel is currently programmed in memory.

2.Press and hold the MEM button for about 1.5 seconds until a beep is heard twice. The MEM indicator should now be off.

Select	Remove	'MEM'Icon
CHANNEL	CHANNEL	OFF
I81Iden	MEM
	D	UII
(0)	+	GS ,Ll
	1)) t
	.-. BEEPI'"

Open Scanning

To commence open scanning, select the OPEN SCAN mode by pressing the OSlGS button when in GS mode. Then press the SCAN button.

The SUNDOWNER UH-099 will commence scanning the programmed channels, and will indicate each channel on the CHANNEL indicator as it is scanned.

When a busy channel is found, the radio will 'lock'onto it, and will remain there for as long as the signal is present, and for 3 seconds after the transmission ceases. This allows the SUNDOWNER UH-099 to hold the channel during short breaks in the conversation. Once the channel has remained clear for 3 seconds, the radio will resume scanning.

If you do not wish to listen to a busy channel, you can SKIP over it by pressing the MEM button on the radio. The receiver will immediately resume scanning.

The SCAN MODE will be cleared when the PRESS- TO-TALK BUTTON is pressed.

NOTE: 1. During the OPEN SCAN mode, the CHANNEL SELECTOR knob is ignored.

2.The scan rate in this mode is 0.1 second per channel. In other words, all 40 channels can be scanned in 4 seconds.

Page 9