Uniden UH-099 owner manual How to Receive, How to Transmit

Page 8

Operation

How to Receive

1.Confirm that the power source, antenna, and microphone are connected properly before proceeding to the following steps.

2.Turn the unit ON by rotating the VOLUME control clockwise.

3.Set the CHANNEL CONTROL knob to the desired channel.

4.Set the VOLUME control to a comfortable listening level.

5.Listen to the background noise from the speaker. Turn the SQUELCH control slowly clockwise just until the noise is eliminated (no signal should be present). Leave the control at this setting. The Squelch is now properly adjusted. The receiver will remain quiet until a signal is actually received. Do not advance the control too far, or some of the weaker signals will not be heard.

How to Transmit

1.Carefully read the SMA Rules and Regulations prior to operating the transmitter.

2.Select the desired channel.

3.To transmit, press the PRESS- TO-TALK button on the microphone. Hold the microphone 2-4 inches from your mouth and slightly to one side so that your voice does not project directly into the microphone (this provides the best results). Speak at a normal level. Never raise your voice or shout into the microphone. Whenever the PRESS- TO-TALK button is pressed, the TX indica- tor will light.

~The Transceiver Voltage Standing Wave Ratio (V.S.WR.)

ill measurement must be performed prior to the use of the

WARNING transmitter. A V.S.WR. ratio in excess of2:1 may damage the transmitter.

Page 7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Rj,, GS UnidE!n$UHF CB TransceiverContents Front Panel Controls Programs semi-duplex operations for channels 1 throughSRF ...11111 OS Microphone PRESS- TO-TALK ButtonBack Panel Ground System Mobile Station InstallationChoosing an Antenna Set the Channel Control knob to the desired channel How to ReceiveHow to Transmit Scanning Programming Scan ChannelsRemoving Group Scan Channels Open ScanningGroup Scanning Removing Open Scan Channels LLJReinstalling Channels into the Scan Group ~E~Call Alarm Receiver Quieting Tone SquelchTone Squelch Scanning Tone CallingTo deactivate the Quiet Condition Receiver QuietingCall Receiving CAL indicator marks the channel where the call is received To deactivate T.Sa ScanningSelecting 5 or 6 Tone Format Lf-Lf-Lf-fUTone TX Selcall Programming Group Calling ExampleTX Selcall ID Format To call Transmitter RadiosTo save new a setting after programming, press I MEM PressPress I TSQ To select, press I MEMFlash From 5 to 6 Tone Format SettingReceiver Selcall ID ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Tone Period Programming020 Rotate the 0 to change the Tone Period valueI=~I~ 500,1000,2000,3000,4000 mSecTOO I ,~ Usethe 0 to change the Lead-in Tone valueNext programmable parameter ToneToneA Alarm Mode Use the 0 to change the Alarm ModeAppears FlashingCall Alarm Continue Mode 00000Memory Backup Preventive MaintenanceTroubleshooting Simplex Operating Mode Duplex Operating Frequencies Controls Indicators ChannelsReceiver Section Measurement ConditionsTransmitter Section 300mA 600mACcir International Or 6 TonesWarranty Procedure for Obtaining Performance or Warranty Inthe eventUniden@
Top Page Image Contents