Uniden UH-099 owner manual Too I ,~, Usethe 0 to change the Lead-in Tone value

Page 26

When finished, pressl MEMIto store onto memory. The displayed Lead-in Delay

ENT

stops flashing and three successive beeps will be heard. pressl TSQI for about 1.5

seconds to exit. The radio returns to normal operation. Or press ITSQ Imomentarily

to go to the next programmable parameter.

Lead-in Tone

The Lead-in Tone, when programmed, "rides" on the Lead-in Delay. Hence, when transmitting a SELCALL ID, a continuous tone will be heard for the duration of the Lead-in Delay.

The main purpose of the Lead-in Tone is to increase the probability of contact between your unit and another radio when TSQ Scanning.

Normally during TSQ Scanning, if a carrier is detected and the unit does not notice SELCALL information on its first "glance" of the particular signal, scanning resumes.

But if a Lead-in Tone is present, the unit continues to wait until the SELCALL ID is received.

4.1From the Lead-in Delay Status (3.1), press ITSQ Iand the following mode appears.

TOO I ,~

,- ,- ,,LI , O'rC

Note: Tone _1 is the factory default setting of the UH-O99 for Lead-in Tone.

4.2Next press IMEM Iand Lead-in Tone Editing is possible.

ENT

TOO I ,~

,- ,- I, LI ,onc

L- Flashing

Usethe 0 to change the Lead-in Tone value.

Channel Knob

Page 25

Image 26

Contents Rj,, GS UnidE!n$UHF CB TransceiverContents Front Panel Controls Programs semi-duplex operations for channels 1 throughSRF ...11111 OS Microphone PRESS- TO-TALK ButtonBack Panel Ground System Mobile Station InstallationChoosing an Antenna Set the Channel Control knob to the desired channel How to ReceiveHow to Transmit Scanning Programming Scan ChannelsRemoving Group Scan Channels Open ScanningGroup Scanning Removing Open Scan Channels LLJReinstalling Channels into the Scan Group ~E~Tone Squelch Scanning Call AlarmReceiver Quieting Tone Squelch Tone CallingTo deactivate the Quiet Condition Receiver QuietingCall Receiving CAL indicator marks the channel where the call is received To deactivate T.Sa ScanningSelecting 5 or 6 Tone Format Lf-Lf-Lf-fUTone TX Selcall Programming Group Calling ExampleTX Selcall ID Format To call Transmitter RadiosPress I TSQ To save new a setting after programming, press I MEMPress To select, press I MEMFlash From 5 to 6 Tone Format SettingReceiver Selcall ID ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Tone Period Programming020 Rotate the 0 to change the Tone Period valueI=~I~ 500,1000,2000,3000,4000 mSecTOO I ,~ Usethe 0 to change the Lead-in Tone valueNext programmable parameter ToneToneA Appears Alarm ModeUse the 0 to change the Alarm Mode FlashingCall Alarm Continue Mode 00000Memory Backup Preventive MaintenanceTroubleshooting Simplex Operating Mode Duplex Operating Frequencies Controls Indicators ChannelsReceiver Section Measurement ConditionsTransmitter Section Ccir International 300mA600mA Or 6 TonesWarranty Procedure for Obtaining Performance or Warranty Inthe eventUniden@