Uniden UH-099 owner manual Appears, Flashing, Use the 0 to change the Alarm Mode

Page 28

Alarm Mode

5.1 From the Lead-in Tone condition (4.1) press ITSQ Iand the following mode

appears.

't,,,- TSQ "LI 'tU'Q

5.2Next press IMEM I and Alarm Mode Editing is possible.

ENT

TOO "

'~JI,,-

'-'u'a"

L.Flashing

I

L-

TSQ "		I		TOO "~	I
,- ,-	"	L.. J	AUra	I ,	L-
( L-a,-"
Call Alarm Continue	Mode
Flashing			t	Call Alam> A"'<><>II Mode

Use the 0 to change the Alarm Mode.

Channel Knob

When finished, press the IMEM Ito store onto memory. The selected Alarm mode

ENT

stops flashing and three successive beeps will be heard. Press ITSQ Ifor about 1.5

seconds to exit. The radio returns to normal operation.

When a received code matches to your Receiver SELCALL IDand you selected the:

Call Alarm Auto Mode

1.The unit will transmit an Acknowledge Tone to the Caller.

2.Emits CALL Alarm for 10 seconds only.

3.Resumes Quiet condition automatically after 20 seconds if the call is not answered.

4.The unit will start decoding again when the 20 second period elapsed and the call remained unanswered.

Page 27

Image 28

Contents Rj,, GS UnidE!n$UHF CB TransceiverContents Front Panel Controls Programs semi-duplex operations for channels 1 throughSRF ...11111 OS Microphone PRESS- TO-TALK ButtonBack Panel Choosing an Antenna Mobile Station InstallationGround System How to Transmit How to ReceiveSet the Channel Control knob to the desired channel Scanning Programming Scan ChannelsRemoving Group Scan Channels Open ScanningGroup Scanning Removing Open Scan Channels LLJReinstalling Channels into the Scan Group ~E~Call Alarm Receiver Quieting Tone SquelchTone Squelch Scanning Tone CallingCall Receiving Receiver QuietingTo deactivate the Quiet Condition CAL indicator marks the channel where the call is received To deactivate T.Sa ScanningTone TX Selcall Programming Lf-Lf-Lf-fUSelecting 5 or 6 Tone Format Group Calling ExampleTX Selcall ID Format To call Transmitter RadiosTo save new a setting after programming, press I MEM PressPress I TSQ To select, press I MEMReceiver Selcall ID From 5 to 6 Tone Format SettingFlash ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Tone Period Programming020 Rotate the 0 to change the Tone Period valueI=~I~ 500,1000,2000,3000,4000 mSecTOO I ,~ Usethe 0 to change the Lead-in Tone valueToneA ToneNext programmable parameter Alarm Mode Use the 0 to change the Alarm ModeAppears FlashingCall Alarm Continue Mode 00000Troubleshooting Preventive MaintenanceMemory Backup Simplex Operating Mode Duplex Operating Frequencies Controls Indicators ChannelsTransmitter Section Measurement ConditionsReceiver Section 300mA 600mACcir International Or 6 TonesWarranty Procedure for Obtaining Performance or Warranty Inthe eventUniden@