Uniden UH-099 owner manual Call Alarm Continue Mode, 00000

Page 29

Call Alarm Continue Mode

1.The unit will transmit an Acknowledge Tone to the Caller.

2.Initially emits an alarm of four successive beeps for 20 seconds and then two successive beeps every four seconds continuously unless answered.

3.Never resumes the Quiet Condition.

4.Continues to check if incoming codes have your Receiver SelcalllD even though

the Quiet Condition is already opened. When detected, it will send an Acknowledge Tone to the caller and then resets the Call Alarm.

.: For both of the above mentioned modes, transmission by using the Press-to- Talk button is possible when the "TSQ" icon is flashing.

Default Setting (Factory Default)

A. RX SELCALL ID:	00000
B. TX SELCALL ID:	00000
C. Tone Period:	40msec
D. Lead-in Delay:	500msec
E. Lead-in Tone:	Tone "1"
F. Alarm:	Auto
IMPORTANT

Be sure that the Tone Format (5 Tone or 6 Tone), Tone Period Setting and the Lead-in Tone for all of the radios in your group are all the same. Otherwise you will not be able to selectively callone anothereffectively.

Page 28

Image 29

Contents UnidE!n$UHF CB Transceiver Rj,, GSContents Programs semi-duplex operations for channels 1 through Front Panel ControlsSRF ...11111 OS PRESS- TO-TALK Button MicrophoneBack Panel Ground System Mobile Station InstallationChoosing an Antenna Set the Channel Control knob to the desired channel How to ReceiveHow to Transmit Programming Scan Channels ScanningOpen Scanning Removing Group Scan ChannelsGroup Scanning LLJ Removing Open Scan Channels~E~ Reinstalling Channels into the Scan GroupReceiver Quieting Tone Squelch Call AlarmTone Squelch Scanning Tone CallingTo deactivate the Quiet Condition Receiver QuietingCall Receiving To deactivate T.Sa Scanning CAL indicator marks the channel where the call is receivedSelecting 5 or 6 Tone Format Lf-Lf-Lf-fUTone TX Selcall Programming Example Group CallingRadios TX Selcall ID Format To call TransmitterPress To save new a setting after programming, press I MEMPress I TSQ To select, press I MEMFlash From 5 to 6 Tone Format SettingReceiver Selcall ID ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Programming Tone PeriodRotate the 0 to change the Tone Period value 020500,1000,2000,3000,4000 mSec I=~I~Usethe 0 to change the Lead-in Tone value TOO I ,~Next programmable parameter ToneToneA Use the 0 to change the Alarm Mode Alarm ModeAppears Flashing00000 Call Alarm Continue ModeMemory Backup Preventive MaintenanceTroubleshooting Simplex Operating Mode Duplex Operating Frequencies Channels Controls IndicatorsReceiver Section Measurement ConditionsTransmitter Section 600mA 300mACcir International Or 6 TonesProcedure for Obtaining Performance or Warranty Inthe event WarrantyUniden@