Uniden UH-099 owner manual Microphone, PRESS- TO-TALK Button

Page 5

Microphone

12

1. PRESS- TO-TALK Button

Use the PRESS- TO-TALKbutton on the microphone to receive and transmit. Press the button to activate the transmitter and release the button to receive.

When transmitting, hold the microphone about two inches from your mouth and speak clearly in a normal voice.

2.TONE CALL CONTROL (CALL) Button

Use the TONE CALL CONTROL (Call) button to check, edit, or transmit the TX Selcalll D. Press the button once and the Selcalll D will be displayed. Under this condition you can change the Selcall ID (See page 16 for TX SELCALL ID Programming). To abort, momentarily press the Call button again. If you want

to transmit the existing code, press and hold the Call button for more than 1.5 seconds.

Page 4

Image 5

Contents UnidE!n$UHF CB Transceiver Rj,, GSContents Programs semi-duplex operations for channels 1 through Front Panel ControlsSRF ...11111 OS PRESS- TO-TALK Button MicrophoneBack Panel Ground System Mobile Station InstallationChoosing an Antenna Set the Channel Control knob to the desired channel How to ReceiveHow to Transmit Programming Scan Channels ScanningOpen Scanning Removing Group Scan ChannelsGroup Scanning LLJ Removing Open Scan Channels~E~ Reinstalling Channels into the Scan GroupReceiver Quieting Tone Squelch Call AlarmTone Squelch Scanning Tone CallingTo deactivate the Quiet Condition Receiver QuietingCall Receiving To deactivate T.Sa Scanning CAL indicator marks the channel where the call is receivedSelecting 5 or 6 Tone Format Lf-Lf-Lf-fUTone TX Selcall Programming Example Group CallingRadios TX Selcall ID Format To call TransmitterPress To save new a setting after programming, press I MEMPress I TSQ To select, press I MEMFlash From 5 to 6 Tone Format SettingReceiver Selcall ID ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Programming Tone PeriodRotate the 0 to change the Tone Period value 020500,1000,2000,3000,4000 mSec I=~I~Usethe 0 to change the Lead-in Tone value TOO I ,~Next programmable parameter ToneToneA Use the 0 to change the Alarm Mode Alarm ModeAppears Flashing00000 Call Alarm Continue ModeMemory Backup Preventive MaintenanceTroubleshooting Simplex Operating Mode Duplex Operating Frequencies Channels Controls IndicatorsReceiver Section Measurement ConditionsTransmitter Section 600mA 300mACcir International Or 6 TonesProcedure for Obtaining Performance or Warranty Inthe event WarrantyUniden@