Uniden UH-099 owner manual ICJI1 IU,-\II, -- TSQ l--lr..-I

Page 22

	TSQ		I
" " " " ,~\I1"		,--	"
Uf-If-IUY	- -	~	~
	11\

Assign a SELCALL number on this position. Follow procedure 1.2 for further

RX SELCALL ID editing. When finished, press IMEM I to save the new

ENT

setting.

1.32 From 6 to 5 Tone Format Setting

Select the 6th digit position, change its setting from the assigned SELCALL number to a space bar [-].

Example

		TSQ		I
	",CI,-		l--	D
I 1 1 U ,-.,\Lt'"
" IC:J ,	I I'

To

IC:JI1 IU,-\II,' -"- TSQ l--l'r..-I

11\

Follow procedure 1.2 for further RX SELCALL IDediting. When finished press

I MEM Ito save the new setting.

ENT

Other SELCALL Parameters

Aside from the Transmitter and Receiver lDs, you should also be familiar with some of the other SELCALL Parameters. This section outlines the following programming modes.

-Tune Period

-Lead-in Delay

-Lead-in Tone

-Alarm

RX SelcalllD, Tone Period, Lead-in Delay, Lead-in Tone, and Alarm Programming are mentioned separately from the TX SELCALL Programming because they are not frequently changed. Special procedures have been designed to prevent accidental programming.

Page 21

Image 22

Contents Rj,, GS UnidE!n$UHF CB TransceiverContents Front Panel Controls Programs semi-duplex operations for channels 1 throughSRF ...11111 OS Microphone PRESS- TO-TALK ButtonBack Panel Choosing an Antenna Mobile Station InstallationGround System How to Transmit How to ReceiveSet the Channel Control knob to the desired channel Scanning Programming Scan ChannelsRemoving Group Scan Channels Open ScanningGroup Scanning Removing Open Scan Channels LLJReinstalling Channels into the Scan Group ~E~Tone Squelch Scanning Call AlarmReceiver Quieting Tone Squelch Tone CallingCall Receiving Receiver QuietingTo deactivate the Quiet Condition CAL indicator marks the channel where the call is received To deactivate T.Sa ScanningTone TX Selcall Programming Lf-Lf-Lf-fUSelecting 5 or 6 Tone Format Group Calling ExampleTX Selcall ID Format To call Transmitter RadiosPress I TSQ To save new a setting after programming, press I MEMPress To select, press I MEMReceiver Selcall ID From 5 to 6 Tone Format SettingFlash ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Tone Period Programming020 Rotate the 0 to change the Tone Period valueI=~I~ 500,1000,2000,3000,4000 mSecTOO I ,~ Usethe 0 to change the Lead-in Tone valueToneA ToneNext programmable parameter Appears Alarm ModeUse the 0 to change the Alarm Mode FlashingCall Alarm Continue Mode 00000Troubleshooting Preventive MaintenanceMemory Backup Simplex Operating Mode Duplex Operating Frequencies Controls Indicators ChannelsTransmitter Section Measurement ConditionsReceiver Section Ccir International 300mA600mA Or 6 TonesWarranty Procedure for Obtaining Performance or Warranty Inthe eventUniden@