Uniden UH-099 owner manual Channels, Controls Indicators

Page 33

General

Channels

Frequency Range

Crystal Oscillator

Microphone

Speaker

Antenna Connector

Jacks & Connectors

Controls

Indicators

Cabinet Size

Weight

Operating Temperature

Power Requirements

SMA Approval

Accessories

Specifications

:40

:476.425MHzto 477.40MHz :3

:600 ohm, Dynamic Type

:8 ohm, 3W

:M-Type

:Mic4P Metal EXT SP 3.50

DC Power 3P Type

:PRESS-TO-TALK Button (Microphone) TONE CALL Button (Microphone) SCAN/SEEK Button

OPEN SCAN/GROUP Button BACK LIGHT CONTROL Button OFFNOLUME Control SQUELCH Control

DUPLEX Button

TONE SQUELCH Button CHANNEL SELECTOR Knob

:DUPLEX Indicator TX Indicator CALL Indicator TSQ Indicator GROUP SCAN Indicator MEMORY Indicator OPEN SCAN Indicator CHANNEL Indicator PRllndicator

S/RF Level Indicator SCAN Indicator

TX/RX FREQUENCY, 5/6 Digit SELCALL ID Indicator

:W: 154.5 mm

H: 52.5 mm

0:173 mm

:1.2 kg

:0° to +55°C

:13.8 VDC Nominal

:Type accepted under SMAS250

:DC power cable with built-in-fuse, microphone, micro- phone hanger mounting bracket screw (2), washer (2) for microphone hanger screw (2),washer (2)for mount- ing bracket

Page 32

Image 33

Contents UnidE!n$UHF CB Transceiver Rj,, GSContents Programs semi-duplex operations for channels 1 through Front Panel ControlsSRF ...11111 OS PRESS- TO-TALK Button MicrophoneBack Panel Mobile Station Installation Choosing an AntennaGround System How to Receive How to TransmitSet the Channel Control knob to the desired channel Programming Scan Channels ScanningOpen Scanning Removing Group Scan ChannelsGroup Scanning LLJ Removing Open Scan Channels~E~ Reinstalling Channels into the Scan GroupReceiver Quieting Tone Squelch Call AlarmTone Squelch Scanning Tone CallingReceiver Quieting Call ReceivingTo deactivate the Quiet Condition To deactivate T.Sa Scanning CAL indicator marks the channel where the call is receivedLf-Lf-Lf-fU Tone TX Selcall ProgrammingSelecting 5 or 6 Tone Format Example Group CallingRadios TX Selcall ID Format To call TransmitterPress To save new a setting after programming, press I MEMPress I TSQ To select, press I MEMFrom 5 to 6 Tone Format Setting Receiver Selcall IDFlash ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Programming Tone PeriodRotate the 0 to change the Tone Period value 020500,1000,2000,3000,4000 mSec I=~I~Usethe 0 to change the Lead-in Tone value TOO I ,~Tone ToneANext programmable parameter Use the 0 to change the Alarm Mode Alarm ModeAppears Flashing00000 Call Alarm Continue ModePreventive Maintenance TroubleshootingMemory Backup Simplex Operating Mode Duplex Operating Frequencies Channels Controls IndicatorsMeasurement Conditions Transmitter SectionReceiver Section 600mA 300mACcir International Or 6 TonesProcedure for Obtaining Performance or Warranty Inthe event WarrantyUniden@