Uniden UH-099 owner manual Press I TSQ, To select, press I MEM

Page 20

5/6 TONE SELCALL PROGRAMMING

Since UH-O99can support either a 5 or 6 tone signalling format, you and your group must decide which format to use. The following is a basic outline of SELCALL Programming.

Press and Hold

ITSQ I on Power ON

RECEIVER CODE

PROGRAMMING

Press	I	I	Press	ITSQ I
	TSQ

TONE PERIOD

PROGRAMMING

Press	ITSQ I
ALARM MODE
PROGRAMMING	LEAD-IN	DELAY
	LEAD-IN	DELAY
	PROGRAMMING
		Press ITSQ I
Press ITSQ I	LEAD-IN	TONE
	PROGRAMMING
To select, press IMEM I
ENT
To save new a setting after programming, press IMEM I
		ENT

To deselect, momentarily, press ITSQI

The unit goes to the next programmable parameter.

To exit, press and hold ITSQ I for more than 1 .5seconds. The unit goes to Normal Operating mode.

Page 19

Image 20

Contents Rj,, GS UnidE!n$UHF CB TransceiverContents Front Panel Controls Programs semi-duplex operations for channels 1 throughSRF ...11111 OS Microphone PRESS- TO-TALK ButtonBack Panel Ground System Mobile Station InstallationChoosing an Antenna Set the Channel Control knob to the desired channel How to ReceiveHow to Transmit Scanning Programming Scan ChannelsRemoving Group Scan Channels Open ScanningGroup Scanning Removing Open Scan Channels LLJReinstalling Channels into the Scan Group ~E~Call Alarm Receiver Quieting Tone SquelchTone Squelch Scanning Tone CallingTo deactivate the Quiet Condition Receiver QuietingCall Receiving CAL indicator marks the channel where the call is received To deactivate T.Sa ScanningSelecting 5 or 6 Tone Format Lf-Lf-Lf-fUTone TX Selcall Programming Group Calling ExampleTX Selcall ID Format To call Transmitter RadiosTo save new a setting after programming, press I MEM PressPress I TSQ To select, press I MEMFlash From 5 to 6 Tone Format SettingReceiver Selcall ID ICJI1 IU,-\II, -- TSQ l--lr..-I Tone Period Tone Period Programming020 Rotate the 0 to change the Tone Period valueI=~I~ 500,1000,2000,3000,4000 mSecTOO I ,~ Usethe 0 to change the Lead-in Tone valueNext programmable parameter ToneToneA Alarm Mode Use the 0 to change the Alarm ModeAppears FlashingCall Alarm Continue Mode 00000Memory Backup Preventive MaintenanceTroubleshooting Simplex Operating Mode Duplex Operating Frequencies Controls Indicators ChannelsReceiver Section Measurement ConditionsTransmitter Section 300mA 600mACcir International Or 6 TonesWarranty Procedure for Obtaining Performance or Warranty Inthe eventUniden@