Sennheiser LV307, LV308 manual Operating menu of the receiver, Configure the receiver, Receiver on

Page 13

Using the receiver

Note:

It is only possible to switch the channel if the lock mode is deac- tivated. If it is deactivated, no lock mode icon appears on the display (see “Activating/deactivating the lock mode” on page 20).

Use the / rocker button (UP/DOWN) to switch between the 20 channels maximum.

The number of selectable channels might be limited when the operator has locked several channels (see “Locking channels for the user” on page 20). Locked channels are not displayed.

The receiver immediately switches to the new channel. If a transmission signal is received on the new channel the green LED lights up.

Attaching the receiver to clothing

The receiver is attached to clothing (e.g. belt, waistband) with the supplied belt clip.

The operating menu of the receiver

The operationg menu of the receiver consists of the user menu and the setup menu.

Within the user menu, the user can switch between the channels via the / rocker button (see “Switching the channel” on page 13).

Within the setup menu, the operator can configure the receiver for daily use.

SETUP	Configure the receiver
	This section describes how to use the setup menu. An overview over
	the menu is given within the chapter “The setup menu of the
	receiver” on page 19.

13

Image 13

Contents Tourguide UHF Page Contents Thank you for choosing Sennheiser Important safety instructions Replacement parts Power sourceSafety check OverloadingDo not solder Safety instructions for Lithium-Ion rechargeable batteriesSystem components Tourguide UHF systemEK 1038 receiver Special featuresOperating controls Segments Capacity approx % Battery icon flashing LOW BAT Operation and battery status indicationRF signal indication IndicationsHow to properly use the battery pack or the batteries Inserting and changing the battery pack/batteriesConnecting the headphones Preparing for useSwitching the receiver on/off Using the receiverAdjusting the volume Switching the channelMenu is given within the chapter The setup menu Configure the receiverOperating menu of the receiver Attaching the receiver to clothingFunction of the buttons in the setup menu Starting the setup menuGetting into the setting mode of a menu Getting into the operating menu of the setup menuSelecting a menu Software stored on a chip in the deviceStoring a setting Adjusting a settingCanceling the entry Exiting the setup menuLOC. OFF LOC. on Setup menu of the receiverActivating/deactivating the lock mode Adjustment tips for the setup menuLocking channels for the user Changing the receiving frequencies of the channelsReleasing locked channels Adjusting the squelch thresholdDisplaying the revision of the firmware Limiting the volume at the headphone outputCopy function Slave Quick charger LED indications Switching the charger on or off Setting up the chargerCascading several chargers Do not place the receiver on delicate surfacesCare and maintenance Using the chargerCharging the rechargeable battery BA Compartments As shown Red LEDSK 100 G2 / SK 300 G2 / SK 500 G2 Channel bank systemQuick charger Delivery includes SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophonesChanging the microphone module Inserting and changing the batterySwitching the radiomicrophone on/off Using the radiomicrophoneMuting the radiomicrophone SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters Inserting and charging the accupack Attaching the microphones Connecting the microphone/line cableUse the microphone clips Positioning the microphonesSwitching the transmitter on/off Using the bodypack transmitterMuting the transmitter Play appears on the display panelMicrophone input, XLR-3 socket Button UP Unbalanced SKP 100 G2 / SKP 500 G2 plug-on transmittersPlugging the transmitter onto the microphone Betriebs- und Batterieanzeige Battery status indication LC display panel Evolution wireless transmitters GLC display panel Mute displayDisplay backlighting Pilot displayButtons Overview of menusGetting into the operating menu Working with the operating menuExiting the operating menu Overview of the operating menu of the transmitters ExitDisply Switching between the channels in a channel bank Switching between channel banksAdjusting the sensitivity Selecting the frequencies to be stored in the channelSKP 500 G2 only Switching the phantom powering on/offSelecting the standard display Loading the factory-preset default settingsEntering a name Activating/deactivating the pilot tone transmission Activating/deactivating the lock modeExiting the operating menu Error checklist TroubleshootingSet transmitter and receiver to Deactivate the muting functionFor the receiver EK Recommendations and tipsFor the radiomicrophones …for the bodypack transmittersProgress you can hear HDX noise reductionInherent Quick charger Accessories and spare partsSKP 100 G2 / SKP 500 G2 plug-on transmitter SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitterEK 1038 receiver Specifications2015charger Deep discharge recovery charge Evolution wireless transmitters GAutomatic security switch-off after 6 h at the latest Plug-in mains unitsTune Chan Channel assignmentManufacturer declarations WarrantyStatements regarding FCC and industry Canada Weee DeclarationManufacturer declarations