Sennheiser LV307, LV308 manual Operating controls, LED indications

Page 23

L 2015 quick charger

Operating controls

Red LED CHARGE/ERROR (2 x)

Green LED READY (2 x)

Charging compartment for BA 2015 rechargeable battery (2 x)

Charging compartment for EK 1038 or bodypack transmitters of the evolution wireless G2 series (2 x)

Air vent

Mains connection

Guiding slot with internal rail (2 x)

LED indications

Each charging compartment has two LEDs which indicate the fol- lowing operating states:

No LED lit:

The charging compartment is ready for operation (provided that the charger is connected to the mains), no rechargeable battery is identified.

All LEDs briefly light up one after the other:

The charger has been connected to the mains and is carrying out a self test.

Red LED	lit:
Red LED	flashing:
Green LED	lit:

The rechargeable battery is being charged.

A problem has occured (see ”Troubleshooting“ on page 51).

The rechargeable battery is fully charged and the charger has switched to trickle charging.

Image 23

Contents Tourguide UHF Page Contents Thank you for choosing Sennheiser Important safety instructions Overloading Power sourceReplacement parts Safety checkDo not solder Safety instructions for Lithium-Ion rechargeable batteriesSystem components Tourguide UHF systemOperating controls Special featuresEK 1038 receiver Indications Operation and battery status indicationSegments Capacity approx % Battery icon flashing LOW BAT RF signal indicationPreparing for use Inserting and changing the battery pack/batteriesHow to properly use the battery pack or the batteries Connecting the headphonesSwitching the channel Using the receiverSwitching the receiver on/off Adjusting the volumeAttaching the receiver to clothing Configure the receiverMenu is given within the chapter The setup menu Operating menu of the receiverFunction of the buttons in the setup menu Starting the setup menuSoftware stored on a chip in the device Getting into the operating menu of the setup menuGetting into the setting mode of a menu Selecting a menuExiting the setup menu Adjusting a settingStoring a setting Canceling the entryLOC. OFF LOC. on Setup menu of the receiverChanging the receiving frequencies of the channels Adjustment tips for the setup menuActivating/deactivating the lock mode Locking channels for the userReleasing locked channels Adjusting the squelch thresholdCopy function Limiting the volume at the headphone outputDisplaying the revision of the firmware Slave Quick charger LED indications Do not place the receiver on delicate surfaces Setting up the chargerSwitching the charger on or off Cascading several chargersCompartments As shown Red LED Using the chargerCare and maintenance Charging the rechargeable battery BASK 100 G2 / SK 300 G2 / SK 500 G2 Channel bank systemQuick charger Delivery includes SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophonesChanging the microphone module Inserting and changing the batterySwitching the radiomicrophone on/off Using the radiomicrophoneMuting the radiomicrophone SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters Inserting and charging the accupack Positioning the microphones Connecting the microphone/line cableAttaching the microphones Use the microphone clipsPlay appears on the display panel Using the bodypack transmitterSwitching the transmitter on/off Muting the transmitterMicrophone input, XLR-3 socket Button UP Unbalanced SKP 100 G2 / SKP 500 G2 plug-on transmittersPlugging the transmitter onto the microphone Betriebs- und Batterieanzeige Mute display LC display panel Evolution wireless transmitters GBattery status indication LC display panelDisplay backlighting Pilot displayButtons Overview of menusExiting the operating menu Working with the operating menuGetting into the operating menu Overview of the operating menu of the transmitters ExitDisply Selecting the frequencies to be stored in the channel Switching between channel banksSwitching between the channels in a channel bank Adjusting the sensitivitySKP 500 G2 only Switching the phantom powering on/offEntering a name Loading the factory-preset default settingsSelecting the standard display Exiting the operating menu Activating/deactivating the lock modeActivating/deactivating the pilot tone transmission Deactivate the muting function TroubleshootingError checklist Set transmitter and receiver to…for the bodypack transmitters Recommendations and tipsFor the receiver EK For the radiomicrophonesInherent HDX noise reductionProgress you can hear Quick charger Accessories and spare partsSKP 100 G2 / SKP 500 G2 plug-on transmitter SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitter2015charger SpecificationsEK 1038 receiver Plug-in mains units Evolution wireless transmitters GDeep discharge recovery charge Automatic security switch-off after 6 h at the latestTune Chan Channel assignmentManufacturer declarations WarrantyStatements regarding FCC and industry Canada Weee DeclarationManufacturer declarations