Sennheiser LV308, LV307 manual Quick charger, Special features

Page 22

L 2015 quick charger

L 2015 quick charger

Special features

The L 2015 quick charger must only be used for automatically charging BA 2015 battery packs – individual rechargeable battery cells or primary cells cannot be charged! The BA 2015 battery pack is delivered as accessory with the EK 1038 receiver and fits to the Sennheiser bodypack receivers ew series G2 as well (see “SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters” on page 34).

The EK 1038 receiver and the SK bodypack transmitters have charg- ing contacts on their sides and can thus be charged with the accupack inserted in the L 2015 charger. When placed into the charger, the transmitters and receiver automatically switch off.

Features of the charger:

yQuick charge in approx. 2½ hours (with completely discharged accupacks and room temperature).

yAutomatic detection of full charge and subsequent switching to trickle charge so the accupacks can remain in the charger even when they have been fully charged.

yHighest possible operational reliability, since correct insertion, temperature and voltage of the accupacks are monitored during charging.

yUp to two accupacks can be charged – optionally separately or inserted in the transmitter or receiver – separatly.

ySeveral chargers can be cascaded together to form a larger charg- ing station which can be powered by a common mains unit (see “Accessories and spare parts” on page 54).

22

Image 22
Contents Tourguide UHF Page Contents Thank you for choosing Sennheiser Important safety instructions Safety check Power sourceReplacement parts OverloadingSafety instructions for Lithium-Ion rechargeable batteries Do not solderTourguide UHF system System componentsEK 1038 receiver Special featuresOperating controls RF signal indication Operation and battery status indicationSegments Capacity approx % Battery icon flashing LOW BAT IndicationsConnecting the headphones Inserting and changing the battery pack/batteriesHow to properly use the battery pack or the batteries Preparing for useAdjusting the volume Using the receiverSwitching the receiver on/off Switching the channelOperating menu of the receiver Configure the receiverMenu is given within the chapter The setup menu Attaching the receiver to clothingStarting the setup menu Function of the buttons in the setup menuSelecting a menu Getting into the operating menu of the setup menuGetting into the setting mode of a menu Software stored on a chip in the deviceCanceling the entry Adjusting a settingStoring a setting Exiting the setup menuSetup menu of the receiver LOC. OFF LOC. onLocking channels for the user Adjustment tips for the setup menuActivating/deactivating the lock mode Changing the receiving frequencies of the channelsAdjusting the squelch threshold Releasing locked channelsDisplaying the revision of the firmware Limiting the volume at the headphone outputCopy function Slave Quick charger LED indications Cascading several chargers Setting up the chargerSwitching the charger on or off Do not place the receiver on delicate surfacesCharging the rechargeable battery BA Using the chargerCare and maintenance Compartments As shown Red LEDChannel bank system SK 100 G2 / SK 300 G2 / SK 500 G2Quick charger SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones Delivery includesInserting and changing the battery Changing the microphone moduleUsing the radiomicrophone Switching the radiomicrophone on/offMuting the radiomicrophone SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters Inserting and charging the accupack Use the microphone clips Connecting the microphone/line cableAttaching the microphones Positioning the microphonesMuting the transmitter Using the bodypack transmitterSwitching the transmitter on/off Play appears on the display panelSKP 100 G2 / SKP 500 G2 plug-on transmitters Microphone input, XLR-3 socket Button UP UnbalancedPlugging the transmitter onto the microphone Betriebs- und Batterieanzeige LC display panel LC display panel Evolution wireless transmitters GBattery status indication Mute displayPilot display Display backlightingOverview of menus ButtonsGetting into the operating menu Working with the operating menuExiting the operating menu Exit Overview of the operating menu of the transmittersDisply Adjusting the sensitivity Switching between channel banksSwitching between the channels in a channel bank Selecting the frequencies to be stored in the channelSwitching the phantom powering on/off SKP 500 G2 onlySelecting the standard display Loading the factory-preset default settingsEntering a name Activating/deactivating the pilot tone transmission Activating/deactivating the lock modeExiting the operating menu Set transmitter and receiver to TroubleshootingError checklist Deactivate the muting functionFor the radiomicrophones Recommendations and tipsFor the receiver EK …for the bodypack transmittersProgress you can hear HDX noise reductionInherent Accessories and spare parts Quick chargerSK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitter SKP 100 G2 / SKP 500 G2 plug-on transmitterEK 1038 receiver Specifications2015charger Automatic security switch-off after 6 h at the latest Evolution wireless transmitters GDeep discharge recovery charge Plug-in mains unitsChannel assignment Tune ChanWarranty Manufacturer declarationsWeee Declaration Statements regarding FCC and industry CanadaManufacturer declarations