Uniden EXI 7926 manual Transferring calls, Using the speakerphone

Page 25

2-Line features (continued)

Transferring calls

1 To transfer a call from the base or the handset, press hold then page/int'com .

2 Answer by pressing page/int'com .

On the base the status LED flashes and line 1 LED turns red.

mute hold

status

memory page/int'com redial/p flash

call id	dn	up	delete
hold	conf	int'com	flash
line 1	conference		line 2
	conference
	mute	hold
	status

The following screen appears:

You may then announce the call with the intercom.

3 To speak to the caller, press line 1 or line 2 .

Intercom (Hold) Line 1

• If no one is available to take the call, return to the caller by pressing line 1 or line 2 to take a message or complete the call.

Using the speakerphone

You may use the phone as speakerphone to answer calls by pressing the line 1 or line 2 button on the base. To hang up, press line 1 or line 2 again.

The base microphone is located under the phone. Position yourself approximately 12 inches away from the base and speak clearly.

If the handset is on the base, you may use either

the base keypad or memory dialing to place a call.	12"

25

Image 25

Contents Page Introduction FeaturesLine2 Controls and functions39 40 41 42 43 Table of contents 11 to Read this firstStep Checking the package contentsChoose the best location Setting up the base unitConnect the base unit Used only when second lineIf your dialing system is Set the switch to Choose the dialing modeIf you arent sure of your dialing system Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Do not use any liquids or solventsSetting up Caller ID options To select Entering your area codeMaking and receiving calls BasicsBasic 2-line operation Handset On Base Handset Off Base Base Only Auto Talk offAnswering a call from the handset Answering a call from the baseMaking a call from the base Using the tone featureMaking a call from the handset Off-hook dialingLast number redial Flash and Call WaitingHandset BasePlacing a call on hold Using the speakerphone mute featureAdjusting the volume controls Using the page featureTraveling out-of-range Selecting a different channelBase ringer volume Line featuresBase speaker volume Line operationWay conferencing Conference Line 1 Line Paging from the base to handset Using your EXI 7926 intercomPaging from the handset to base Transferring calls Using the speakerphoneStoring a phone number in memory Memory featuresOn the handset On the base Editing a phone number in memory Press delete/flash to remove any unwanted From the handset Erasing a number from memoryFrom the base At the base Using memory dialingUsing Caller ID Caller ID featuresScreening your calls Reviewing Caller ID name/numbersCalling a Caller ID name/number Select Location screen appears. Use Storing a Caller ID number in a memory locationDeleting a Caller ID message Deleting all Caller ID name/numbers Using Cidcw Caller ID with Call WaitingAdditional information Headset installationChanging the digital security code Headset JackStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting To attach the beltclip To remove the beltclip Installing the beltclipBattery replacement and handling MaintenanceWhen slightly dirty When very dirtySymptom Suggestion TroubleshootingGeneral SpecificationsBase unit HandsetW, X, Y, Z Index