Uniden EXI 7926 manual Mounting the base unit on a wall, Standard wall plate mounting

Page 39

Plug the telephone line cord into the telephone outlet.

Wrap the AC adapter cord inside the molded wiring channel. Then wrap the cord around the strain relief notch.

Plug the AC adapter into a standard 120VAC wall outlet.

Raise the antenna to a vertical position.

Additional information

Mounting the base unit on a wall

Standard wall plate mounting

This phone can be mounted on any standard telephone wall plate.

1	1 Snap the wall mount adapter into the
	notches on the base.

2, 3, 4, 5, 6, 7

Wall plate

2 Plug the telephone line cord to the TEL LINE jack and the AC adapter to the DC IN 9V jack.

3

4

5

6

7 Align the mounting slots on the base.

AC adapter

with the mounting posts on the wall. Push in and down until the phone is firmly seated.

AC outlet

39

Image 39

Contents Page Introduction FeaturesLine2 Controls and functions39 40 41 42 43 Table of contents 11 to Read this firstStep Checking the package contentsChoose the best location Setting up the base unitConnect the base unit Used only when second lineChoose the dialing mode If your dialing system is Set the switch toIf you arent sure of your dialing system Preparing the battery pack Do not use any liquids or solvents Battery use time per chargeWhen the battery charge becomes low Cleaning the battery contactsSetting up Caller ID options To select Entering your area codeHandset On Base Handset Off Base Base Only Auto Talk off BasicsMaking and receiving calls Basic 2-line operationAnswering a call from the handset Answering a call from the baseOff-hook dialing Using the tone featureMaking a call from the base Making a call from the handsetBase Flash and Call WaitingLast number redial HandsetPlacing a call on hold Using the speakerphone mute featureSelecting a different channel Using the page featureAdjusting the volume controls Traveling out-of-rangeLine operation Line featuresBase ringer volume Base speaker volumeWay conferencing Conference Line 1 Line Using your EXI 7926 intercom Paging from the base to handsetPaging from the handset to base Transferring calls Using the speakerphoneMemory features Storing a phone number in memoryOn the handset On the base Editing a phone number in memory Press delete/flash to remove any unwanted From the handset Erasing a number from memoryFrom the base At the base Using memory dialingReviewing Caller ID name/numbers Caller ID featuresUsing Caller ID Screening your callsCalling a Caller ID name/number Select Location screen appears. Use Storing a Caller ID number in a memory locationDeleting a Caller ID message Deleting all Caller ID name/numbers Using Cidcw Caller ID with Call WaitingHeadset Jack Headset installationAdditional information Changing the digital security codeStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting To attach the beltclip To remove the beltclip Installing the beltclipWhen very dirty MaintenanceBattery replacement and handling When slightly dirtySymptom Suggestion TroubleshootingHandset SpecificationsGeneral Base unitW, X, Y, Z Index