Uniden EXI 7926 manual Connect the base unit, Used only when second line

Page 9

Step 2 (continued)

Connect the base unit

If you want to install the base unit on the wall, see page 39.

	(Used only when second line
Route the cord.	connects to a separate jack.)

2

To AC outlet

To DC IN 9V

1

AC adapter (supplied)

To telephone outlet

Telephone line cord (supplied)

To TEL LINE

3

Note

1 Connect the telephone line cord to the TEL LINE jack and to a telephone outlet.

2 Connect the AC adapter to the DC IN 9V jack and to a standard 120VAC wall outlet.

3 Set base unit on a desk or tabletop and place the handset into the base unit.

Then raise the antenna to a vertical position.

Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical hazard,

9

Image 9

Contents Page Introduction FeaturesLine2 Controls and functions39 40 41 42 43 Table of contents 11 to Read this firstStep Checking the package contentsChoose the best location Setting up the base unitConnect the base unit Used only when second lineChoose the dialing mode If your dialing system is Set the switch toIf you arent sure of your dialing system Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Do not use any liquids or solventsSetting up Caller ID options To select Entering your area codeMaking and receiving calls BasicsBasic 2-line operation Handset On Base Handset Off Base Base Only Auto Talk offAnswering a call from the handset Answering a call from the baseMaking a call from the base Using the tone featureMaking a call from the handset Off-hook dialingLast number redial Flash and Call WaitingHandset BasePlacing a call on hold Using the speakerphone mute featureAdjusting the volume controls Using the page featureTraveling out-of-range Selecting a different channelBase ringer volume Line featuresBase speaker volume Line operationWay conferencing Conference Line 1 Line Using your EXI 7926 intercom Paging from the base to handsetPaging from the handset to base Transferring calls Using the speakerphoneMemory features Storing a phone number in memoryOn the handset On the base Editing a phone number in memory Press delete/flash to remove any unwanted From the handset Erasing a number from memoryFrom the base At the base Using memory dialingUsing Caller ID Caller ID featuresScreening your calls Reviewing Caller ID name/numbersCalling a Caller ID name/number Select Location screen appears. Use Storing a Caller ID number in a memory locationDeleting a Caller ID message Deleting all Caller ID name/numbers Using Cidcw Caller ID with Call WaitingAdditional information Headset installationChanging the digital security code Headset JackStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting To attach the beltclip To remove the beltclip Installing the beltclipBattery replacement and handling MaintenanceWhen slightly dirty When very dirtySymptom Suggestion TroubleshootingGeneral SpecificationsBase unit HandsetW, X, Y, Z Index