SETUP PROCEDURES
■Prior to Setup
●Turning On the Power
POWER
ON
SIGNAL GND
OFF
OPERATE
TIMER
ALARM
SUSPEND
DAYLIGHT
SAVINGS
●Turning Off the Power
DISPLAY SELECT | SETUP/ESC |
|
| PUSH– | PAUSE SET |
STOP | PLAY | REC | / | / | |
|
| PLAY MODE SELECT |
|
|
|
LCD CONTRAST | ALARM SEARCH | STEP | REW/FF |
|
|
|
|
|
|
| |
|
| / | / |
|
|
Digital Disk Recorder
DISPLAY SELECT
LCD CONTRAST
1.Plug the power cord into the AC outlet.
2.Turn on the power switch on the rear panel.
The operate LED lights, and the date, time and operat- ing status are displayed on the LCD.
Note: Avoid turning the power on and off within a short time. Allow at least 5 seconds from off to on and vice versa.
| TIMER | HDD | Confirm that |
| ALARM |
| |
OPERATE | SUSPEND | FULL | the HDD access |
|
| ||
| DAYLIGHT | LOCK | indicator is off. |
| SAVINGS | ||
|
|
|
|
POWER
ON
SIGNAL GND
OFF
1.Press the stop button to quit recording or playback. Make certain that the HDD access lamp turns off.
2.Turn off the power switch on the rear panel.
The operate LED goes out, and the operating status on the LCD disappears.
Note:
•Do not turn off the power while the HDD access lamp is on.
•Do not leave the unit turned off for a long time. Supply AC power to the unit and turn it on to charge up the backup battery.
15