Panasonic WJ-HD100 operating instructions Motion Detector Setup 306 VMD SETUP

2.Rotate the JogDial to select ON or OFF.

ON: Buzzer beeps while alarm is active.

OFF: Buzzer does not beep.

●Motion Detector Setup 306 VMD SETUP

A VMD or Video Motion Detector senses changes in the video signals within a preset area and supplies alarm out- put. When a change is detected, the recorder starts recording. The detection sensitivity and area are selected on this menu.

	ALARM SETUP
REC MODE		SF- 12H
REC	RATE	15FPS
REC	QUALITY	10(1-10)
DURATION		10S
ALARM	BUZZER	ON
VMD SETUP		OFF

1.Move the cursor to VMD SETUP with the up [▲] or down [▼] button.

2.Rotate the JogDial to select the desired parameter, then press the JogDial. The default is OFF.

[LOW ]: Low sensitivity motion detection is enabled.

[MID ]: Medium sensitivity motion detection is enabled.

[HIGH ]: High sensitivity motion detection is enabled.

[OFF]: Motion detection is disabled.

The area setup window appears with an asterisk when other than OFF is selected. The asterisk represents the upper-left or bottom-right of the detection area. The division lines are not actually displayed on the monitor.

Notes:

•VMD should be used with an ordinary camera input to the unit. Select [OFF] to avoid useless VMD when a video multiplexer or combination camera supplies the input to the unit.

•Make sure that the date and status displays are not located within the motion detection area on the monitor. Otherwise the motion detector could be misled.

•Set the ALARM SUSPEND to ON with the LCD button when VMD is unnecessarily activated during the VMD setup.

•VMD does not function while playing back.

3.Set the upper-left end of the detection area. Move the asterisk to the right or left with the JogDial, and up or down by pressing the up [▲] or down [▼] button.

REW/FF
/
STEP
/
PUSH • PAUSE	SET
/	/

4.Press the JogDial to enter the upper-left end of the detection area. The asterisk position is highlighted.

5.Set the bottom-right end of the detection area similar to steps 3 and 4 above.

6.Press the JogDial. The area is highlighted.

Up to 4 areas can be selected. These may partially overlap. Repeat steps 3 to 6 to select more areas. To unselect an area, move the cursor to the upper-left end of the area, and then press the JogDial.

q e

w

r

28