Panasonic WJ-HD100 Rear View, @1@3@4@6 @7 @8@9, #6#7, @2 @5, #0 #1#2#3#4, @1Audio Input AUDIO IN

!7REW/FF and Up Button [REW/FF 1/2] [D]

Press this button to rewind or fast-forward the recorded field. The LED lights in the REW/FF mode.

Press this button to move the cursor upward in a setup menu on the monitor.

!8JogDial [PUSH – ❚❚PAUSE] [SET]

Press the JogDial to pause or restart playback.

Rotate the JogDial to access the desired field while rewinding, fast-forward and playing back.

Rotate the JogDial to search the oldest picture record- ed on the disk for playing back in chronological order. Rotate the JogDial to select a parameter in a setup menu.

Press the JogDial to enter the selected parameter and move the cursor to the next position on a setup menu. Hold down the JogDial to copy still pictures to the CompactFlash card.

■Rear View

@1@3@4@6 @7 @8@9

#5

#6#7

JOG-RIGHT

G ALARM SEARCH STEP

STOP/SETUP

AUTO OFF OUT

DISK END OUT

RECOVER OUT RESET IN

POWER

IN

IN

(EXT REC)

JOG-CLICK

JOG-LEFT

PLAY OUT

REC OUT

G RECALL

REW/FF

ON

PLAY

REC

G OUT IN

OUT IN

OUT

SIGNAL GND

OUT

IN

OUT

OFF

AUDIO

CAMERA

VIDEO

MONITOR OUT

RS-232C

DATA

MODE

REMOTE

TIME

SERIES

ALARM

SW OUT

(PLAY)

ADJUST

RECORD

@2 @5

@1Audio Input [AUDIO IN]

RCA standard jack accepts an unbalanced –10 dB and 10 kΩ line input audio signal supplied from an external device.

@2Audio Output [AUDIO OUT]

RCA standard jack supplies an unbalanced –10 dB and 600 Ω line output audio signal to an external device.

@3Camera Switching Output [CAMERA SW OUT]

This jack is for connecting an external device such as a video multiplexer receiving multiple camera inputs. The switching signal supplied makes the connected device switch from one camera to the other. Use this terminal only when the recording field rate is lower than 10 fps.

@4Video Input [VIDEO IN]

This BNC accepts a video signal supplied from a cam- era or video multiplexer. A 75 Ω termination is made unless the video output terminal is connected.

@5Video Output Connector [VIDEO OUT]

This BNC supplies a video signal looped through the video input terminal. Connect with a video monitor to check the input picture, or the next WJ-HD100 in a SERIES connection.

#0 #1#2#3#4 #8

@6Monitor Output [MONITOR OUT (PLAY)]

This BNC supplies playback pictures stored on the hard disk, or setup windows. Connect with a video monitor.

@7RS-232C Port [RS-232C]

Through this 9-pin D-Sub connector the digital disk recorder communicates with the personal computer. Use a reverse type cable for connection with the per- sonal computer. Protocol and commands are described in APPENDIX.

@8Data Port [DATA]

Connect with equipment in the PS • Data chain or a sys- tem controller.

@9Mode Switch [MODE]

Use this switch for setting unit addresses and initializing all disk contents and setup data.

Terminal Board

#0Remote In Terminal

These are connected with switches for external control of major operations on the front panel such as JOG-

CLICK, JOG-LEFT, JOG-RIGHT, ALARM SEARCH, STEP, REW/FF, STOP/SETUP, PLAY and REC.

#1Time Adjust Terminal

IN and OUT terminals for synchronizing the internal clock with connected external devices.

7