Panasonic WJ-HD100 Manual Recording, Internal Timer Recording, Power-onRecording

■Recording

●Manual Recording

Recording is possible at any time except during the setup operation. The video supplied to the input terminal is recorded with the recording mode, field rate and picture quality preset in the REC SETUP menu.

DISPLAY SELECT

LCD CONTRAST

Note: A reserved recording will interrupt playback and start at the reserved start time.

	2		1
DISPLAY SELECT	SETU/ESC			PUSH–	PAUSE SET
	STOP	PLAY	REC	/	/
		PLAY MODE SELECT
LCD CONTRAST	ALARM SEARCH	STEP	REW/FF
		/	/

Digital Disk Recorder WJ-HD

DISPLAY SELECT

LCD CONTRAST

1.Press the [● REC] button to start recording.

2.Press the [■ STOP] button to stop recording.

Press the LCD button to the right or left to toggle between the mode and capacity displays. The displays change both on the LCD and on the monitor while recording.

Press the LCD button upward or downward to display the [RECTIME INFO.]. The remaining time and the total avail- able recording time are displayed on the LCD.

DISPLAY SELECT

LCD CONTRAST

Remaining available time Total available recording time

●Internal Timer Recording

Internal timer recording begins when the reserved start time comes, and continues until the reserved end time comes. The reservations are made in the INTERNAL TIMER REC menu (page 29).

1.Press the LCD button downward to display [Timer REC] on the LCD.

2.Press the LCD button to the right or left to select [INT], [EXT] or [OFF]. The default value is OFF.

[OFF]: Reservations are made but not implemented.

[INT]: The internal timer triggers recording at the reserved times.

[EXT]: Enables power-on recording with the use of an external timer switch. Power-on recording is detailed as follows.

●Power-on Recording

			Timer
			Switch
		AC Mains
TIMER	HDD	MEMORY CARD	SETU/ESC			PUSH– PAUSE SET
			DISPLAY SELECT STOP	PLAY	REC /	/
ALARM	FULL
OPERATE SUSPEND			PLAY MODE SELECT
DAYLIGHT	LOCK		ALARM SEARCH	STEP	REW/FF
SAVING			LCD CONTRAST
				/	/

Digital Disk Recorder WJ-HD

For power-on recording select [EXT] in the above procedures with the LCD button. This enables the unit to start recording every day at a specific time with use of a timer switch that controls the AC mains supplied to the unit. Make certain to keep the POWER switch on the rear of the unit set to ON.

Note: When [EXT] is selected for power-on recording, reserved recording is disabled.

●Alarm Recording

Sensor

	TIMER	HDD	MEMORY CARD	DISPLAY SELECT	SETU/ESC			PUSH–	PAUSE SET
					STOP	PLAY	REC	/	/
	ALARM	FULL
OPERATE	SUSPEND					PLAY MODE SELECT
	DAYLIGHT	LOCK			ALARM SEARCH	STEP	REW/FF
	SAVINGS			LCD CONTRAST
						/	/

Digital Disk Recorder WJ-HD

Built-in

VMD

Alarm recording starts when an externally connected sen- sor is turned on, or the built-in VMD (Video Motion Detector) is activated.

34