Panasonic WJ-HD200 manual Baud Rate Baud Rate, Data Bit Data BIT, Parity Check Parity Check

●Baud Rate BAUD RATE

1.Move the cursor to BAUD RATE with the [D] or [C] but- ton.

2.Select the rate with the JogDial, and press the JogDial. The default value is 9600 bits per second.

4800: 4 800 bps

9600: 9 600 bps*

19200: 19 200 bps

●Data Bit DATA BIT

1.Move the cursor to DATA BIT with the [D] or [C] but- ton.

2.Select the bit length with the JogDial. The default value is 8 bits.

7:7 bits*

8:8 bits; select 8 when using the PS• DATA protocol.

●Parity Check PARITY CHECK

1.Move the cursor to PARITY CHECK with the [D] or [C] button.

2.Select the check mode with the JogDial. The default is NONE.

NONE: No parity check

EVEN: Even parity

ODD: Odd parity*

●Stop Bit STOP BIT

1.Move the cursor to STOP BIT with the [D] or [C] but- ton.

2.Select the number of stop bits with the JogDial. The default is 1.

1:1 bit*

2:2 bits

●Wait Time WAIT TIME

The unit retransmits data after waiting the specified time if there is no response from the connected device.

1.Move the cursor to WAIT TIME with the [D] or [C] but- ton.

2.Select the waiting time with the JogDial. The default is OFF.

OFF: Retransmission is disabled. *

100 MS: 100 m seconds

200 MS: 200 m seconds

1 S: 1 second

●Control Unit Address CTL-UNIT ADDRESS (exclusive for PS •DATA)

When the recorder performs as a controller in the system, the unit address can be set from the setup menu on the monitor.

1.Move the cursor to CTL-UNIT ADDRESS with the [D] or [C] button.

2.Select the address with the JogDial. The default value is 1.

Assignable address: From 1 to 99, must be unique in the chain.

Note: Assign an address except 1 to WJ-HD200 when using a system controller in the system.

●System Unit Address SYS-UNIT ADDRESS (exclusive for PS • DATA)

When the recorder performs as a system unit, the unit address can be set from the setup menu on the monitor.

1.Move the cursor to SYS-UNIT ADDRESS with the [D] or [C] button.

2.Select the address with the JogDial. The default value is 1.

Assignable address: From 1 to 99, must be unique in the chain.

●Alarm Data ALARM DATA (exclusive for PS • DATA)

The recorder pauses before sending a notice to the con- nected system controller when an alarm operates.

1.Move the cursor to ALARM DATA with the [D] or [C] button.

2.Select the parameter with the JogDial, and press the Jogdial.

The default is 1S.

OFF: Select this when no system controller is connect- ed.

0S: Pauses no time.

1S: Pauses 1 second.

5S: Pauses 5 seconds.

37