Bdabc C ef
Power Supply
Preparations
Using the AC adaptor
Connect the AC adaptor supplied.
aDC IN jack (DC IN 4.5 V ) b Right side panel of the unit
c AC adaptor
d AC power outlet
Note:
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an AC power outlet.
Using dry-cell batteries (not included)
After disconnecting the AC adaptor, insert two “R6” (LR6) alkaline batteries.
The procedure for inserting and removing
Using external battery case
Open the battery cover of the external battery case (sup- plied) and insert two “R6” (LR6) alkaline batteries (not included) into the battery compartment. Then, install the external battery case in the unit by turning the knob of the battery case.
eBottom of the unit
Battery indicator
fBattery indicator
This indicator lights when the batteries are almost out of power. Power is shut off a short while later.
Rechargeable batteries: Recharge batteries.
Notes:
•The length of time the unit can continue further opera- tion after the battery indicator lights differs depending on the type of batteries used.
•The battery indicator may not light if rechargeable bat- teries, other than those designated by JVC, are used.
Tip:
Turning off the
If the unit malfunctions or freezes during use, disconnect the AC adaptor and batteries. Then, connect the AC adaptor and batteries, and op- erate the unit again.
7