Lincoln Electric CV-305 manual CV Power Source to AN LN-25

WARNING

ELECTRIC

SHOCK

CAN KILL

Turn off input power to the Welding Power Source using the disconnect switch at the fuse box Before connecting the wire feeder.

Only qualified persons should install, use or

service this machine.

F-5

CV/CV-I	14 PIN	OPTIONAL K857
		REMOTE CONTROL
POWER SOURCE	AMPHENOL

N.C.

+	-		OPTIONAL K864 REMOTE
			CONTROL ADAPTER
CV-305		OPTIONAL	LN-25
		K484 JUMPER
			WIRE FEEDER
		PLUG
		N.D.
		TO WORK
		ELECTRODE CABLE

N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION. N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF",

REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE.

N.C. USE OF THE K857 REMOTE CONTROL REQUIRES INSTALLATION OF A K864 REMOTE CONTROL ADAPTER TO THE 14 PIN AMPHENOL OF THE POWER SOURCE.

N.D. CONNECT THE K484 JUMPER PLUG DIRECTLY TO THE 14 PIN AMPHENOL OF THE POWER SOURCE IF NO REMOTE CONTROL IS USED.

IF USING A K857 REMOTE CONTROL,CONNECT THE K484 JUMPER PLUG TO THE 14 PIN AMPHENOL OF THE K864 REMOTE CONTROL ADAPTER.

THE POWER SOURCE WELDING TERMINALS ARE ALWAYS "HOT" WHEN THE K484 JUMPER

6-18-93

S20661

CV POWER SOURCE TO AN LN-25

DIAGRAMS

F-5