Lincoln Electric CV-305 manual Lincoln Power Source to AN LN-742, Wire

WARNING

ELECTRIC

SHOCK

CAN KILL

Turn off (0) the power switch on the Welding Power Source before connecting the wire feeder.

Only qualified persons should install, use or service this machine.

F-7

N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION.

N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF", REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE AND SET WIRE FEEDER VOLTMETER POLARITY SWITCH ON POWER SOURCE TO PROPER POLARITY.

N.C. PINS NOT LISTED ARE NOT CONNECTED ON CABLE.

N.D. IF USING K589-1, REMOTE CONTROL KIT,

SET POWER SOURCE CONTROL SWITCH TO "REMOTE" POSITION.

DIAGRAMS

FUNCTIONS ARE LISTED FOR REFERENCE ONLY AND EACH MAY OR MAY NOT BE PRESENT IN YOUR EQUIPMENT.

(SEE APPROPRIATE WIRING DIAGRAM)

K=42

I=41

H=21

E=77F=76

14-SOCKET BOX RECEPTACLE, FRONT VIEW AND 14-PIN CABLE PLUG, REAR VIEW

K=42

I=41

C=2

14-SOCKET BOX RECEPTACLE, REAR VIEW AND 14-PIN CABLE PLUG, FRONT VIEW

Modified 7/04

S20409

LINCOLN POWER SOURCE TO AN LN-742

F-7