Lincoln Electric CV-305 manual Power Source to AN LN-25 / K444-1

Page 33

CV/CV-I POWER SOURCE TO LN-25 WITH K444-1 OPTION CONNECTION DIAGRAM

F-6

WARNING

ELECTRIC

SHOCK

CAN KILL

Turn off input power to the Welding Power Source using the disconnect switch at the fuse box Before connecting the wire feeder.

Only qualified persons should install, use or

service this machine.

CV

CV-305

CV/CV-I	14 PIN
POWER SOURCE	AMPHENOL
N.D.	OPTIONAL K864 REMOTE
	CONTROL ADAPTER

+	-
		N.C.		LN-25
		N.C.		WIRE FEEDER
				WIRE FEEDER
			OPTIONAL	WITH K444-1 OPTION
			OPTIONAL
	TO WORK		K484 JUMPER
	TO WORK		PLUG

ELECTRODE CABLE

N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION.

N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF", REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE, SWITCH LN-25 POLARITY SWITCH.

N.C. CONNECT THE K484 JUMPER PLUG TO THE 14 PIN RECEPTACLE OF THE K864 REMOTE CONTROL ADAPTER. CONNECT THE 6 PIN PLUG FROM THE LN-25 (WITH K444-1 OPTION) TO THE 6 PIN RECEPTACLE OF THE K864

REMOTE CONTROL ADAPTER. SWITCH THE POWER SOURCE "LOCAL/REMOTE" SWITCH TO REMOTE. N.D. THE POWER SOURCE TERMINALS ARE ALWAYS "HOT" WHEN THE K484 JUMPER

PLUG KIT IS INSTALLED.

6-18-93

CLEVELAND, OHIO U.S.A.	S20663

POWER SOURCE TO AN LN-25 / K444-1

DIAGRAMS

F-6

Image 33

Contents

Idealarc CV-305February California Proposition 65 Warnings SafetyElectric Shock can kill Cylinder may explode if damaged Sûreté Pour Soudage a L’Arc Précautions DE SûretéThank You Table of Contents Technical Specifications Idealarc CV-305 InstallationInput Connections Safety PrecautionsSelect Suitable Location StackingOutput Connections Field Installed OptionsParalleling Operation Operating InstructionsGeneral Warnings Indicates Warning Information Located On Right Case Side Design Features Operational Features and ControlsPower Source Operation General DescriptionThermal Protection Indication Light Controls and Output SettingsWire Feeder Voltmeter Switch Auxiliary Power Starting the MachineOverload Protection Factory Installed OPTIONS/ACCESSORIES AccessoriesField Installed Options Compatible Lincoln EquipmentGeneral Maintenance MaintenanceSafety Precautions Machine and Circuit ProtectionHOW to USE Troubleshooting Guide TroubleshootingError Code Trouble Remedy BUILT-IN Diagnostic Routines and Error CodesProblems Possible Recommended Symptoms Machine Troubleshooting GuideProblems Possible Recommended Poor arc characteristics Control PC Board defective Contact your local Lincoln Options Troubleshooting GuideMeter PC Board Control PC BoardOptional K857 Remote Control Check Fault Protection OperationOutput Voltage Checking Snubber CircuitWiring Diagram CV-305 60Hz DiagramsCV Power Source to AN LN-7 and K857 Adapter Power Source to a K867 / K775 / LN CV Power Source to AN LN-25 Power Source to AN LN-25 / K444-1 Wire Lincoln Power Source to AN LN-742Installation Instructions TWIST-MATE Cable Plug Installation Instructions Feeders Connection of NON-LINCOLN WireDimension Print Precaucion Warnung

Related manuals

Manual 41 pages 59.93 Kb

Manual 4 pages 57.89 Kb