Lincoln Electric IM10024 manual NON-STANDARD Safety Information, Location and Mounting

Page 12

A-5	INSTALLATION	A-5

SAFETY PRECAUTIONS

Read this entire installation section before you start installation.

WARNING

ELECTRIC SHOCK can kill.

•Only qualified personnel should per- form this installation.

•Turn the input power OFF at the dis- connect switch or fuse box before working on this equipment. Turn off the input power to any other equip- ment connected to the welding sys- tem at the disconnect switch or fuse box before working on the equip- ment.

•Do not touch electrically hot parts.

-------------------------------------------------------------

NON-STANDARD SAFETY INFORMATION

CAUTION

The PF-10S series of wire drives may be at weld- ing voltage potential when the output of the power source is active.

------------------------------------------------------------------------

INPUT AND GROUND CONNECTIONS Only a qualified electrician should connect the MAXsa™ 22 & 29 WIRE DRIVES. Wire Drive Installation should be made in accordance with the appropriate National Electrical Code, all local codes and the information in this manual.

LOCATION AND MOUNTING

The MAXsa™ Wire Drivewill operate in harsh environ- ments.

HIGH FREQUENCY PROTECTION

Locate the MAXsa™ Wire Driveaway from radio con- trolled machinery.

MAXsa™ 22 & 29 WIRE DRIVES

Image 12

Contents MAXsa 22 & 29 Wire Drives Safety California Proposition 65 WarningsElectric Shock can kill Welding and Cutting Sparks can Cause fire or explosion IiiLES Machines À Souder À Thank You Table of Contents MAXsa 22 & 29 Wire Drives 1PRODUCT DESCRIPTIONA-1DESIGNClosed-loopFEATURESspeedcontrol- .MAXsa General InformationInstallation Figure A.2 Location of MAXsa 29 ComponentsSpecifications Width DepthNON-STANDARD Safety Information Location and MountingHigh Frequency Protection Mounting Dimensions System ConnectionsConfiguration Figure A.3Wire Feed Mechanism Gear Ratio Conversion Kits SeeTable A.1 Drive Roll Kits Remote Sense Lead Specifications Electrode ConnectionsTable A.1 Output Cable Guidelines K325 TC-3 Travel Carriage K325HC5-StoStandard70/min 127mm- 9521 toratio1.88M/mimInstallation Figure A.6 Wire Drive MountingInclined Operation of TC-3 Figure A.10 Inclined OperationDrive Gear Tracking Carriage Bearing TrackingHead Position Adjustments Maxsa 22 & 29 Wire DrivesOperation Starting TechniquesFigure B.1 Feed Head Adjustment Accessories Follow these stepsSearch Connect the lug on the electrode cables from K226 Contact Assembly Model K226-TCurrent Ratings Long Stickout ExtensionLoading of Wire K148 Nozzle InstallationOperation K285 Installation to the K148 K285 Concentric Flux ConeK285 Installation with K149 Figure C.10 K285/K149 K285 installation with the K129K285 Used in Horizontal Fillet Applications With K148 or K148/K149 combination AfterWith the K129 Tiny Twin-Arc No zle After K285 in Deep Narrow Gap ApplicationsK29 Vertical Head Adjuster Adjustment and LockingK96 Horizontal Head Adjuster Installation See Figure C.14For .045 through 5/641.0-2.0mm Wires K129 Tiny Twinarc KITNozzle Installation Figure C.17K225 Submerged ARC Twinarc KIT Figure C.18 K225 Twinarc ComponentsNozzle Installation See Figure C.18 Figure C.20K281 Solid Wire Straightener for Wire Loading and AdjustmentTiny Twinarc Maintenance Electric Shock can killSense Lead Fuse Troubleshooting HOW to USE Troubleshooting GuideOutput Problems Diagrams Dimension Print L13370Precaucion Warnung