Lincoln Electric IM10024 manual Configuration, Figure A.3

A-7	INSTALLATION		A-7
CONFIGURATION		5. Carefully disconnect the Motor leads from the har-
CHANGING THE WIRE DRIVE		ness by pulling the quick-connect terminals apart.
The MAXsa™ 22 & 29 WIRE DRIVES can be recon-
		6. Reverse the motor leads and reconnect the quick-
figured to fit in any hard automation application.		connect terminals (see the Wiring Diagram).
As shipped, the MAXsa™ 22 & 29 WIRE DRIVES		7. Carefully replace the wire harness back into the
Drive Rolls rotate clockwise to feed the wire down.		Connection Box and place back onto the Motor
Reconfiguring the Wire Drive per Figure A.3 may		housing locating over the Motor lead grommet.
require reversing the direction of the motor. This is		Ensure that the tachometer leads are completely
accomplished by reversing the motor polarity so that		covered by the Channel that snaps into the
the wire will feed correctly. Follow these instructions to		Connection Box.	The Connection Box assembly
reverse the motor polarity. See the	Wiring Diagram in	should be pushed all the way up to the Motor-to-
Section F of this manual		Gearbox Adapter Plate.
1. Remove all power from the MAXsa™ Wire Drives.		8. Before securing the Connection Box to the Motor
2. Disconnect the Control Cable from the MAXsa™		housing with the Band Strap, ensure that none of
		the harness leads are being pinched underneath
Wire Drive Connection Box.		the edges of the Connection Box and Channel.
3. Loosen the fastener from the Band Strap to the		9. Place the Band Strap into the "T" slot on the side
Connection Box, which secures the assembly to the		of the Connection Box and wrap it around the
Motor housing, and expose the leads inside of the		Motor housing.
Connection Box.		10. Replace the fastener between the Band Strap and
4. Locate the Motor leads that go from the Motor to
		the Connection Box. Tighten so that the Connection
the Control Cable connector on the inside of the		Box cannot move on the Motor housing.
Connection Box.

FIGURE A.3

Loosen Socket

Head Screw to Rotate

Motor/Gearbox Assembly

Remove ConnectionBox to Change Motor Polarity

Rotate	Loosen Socket	Rotate
	Head Screw to
	Rotate Feedplate

MAXsa™ 22 & 29 WIRE DRIVES