WallMaster® Thru-the-Wall
SEALINGGASKET INSTALLATIONSTALLATION INSTRUCTIONS
WARNING
MECHANICALNICAL HAZARD
CUT/SEVER
Sharp edges and corners. Be careful with
Be careful with the sharp edges and corners. the sharp edges and corner. Wear protective Wear protective clothing and gloves, etc. clothing and gloves, etc.
Failure to do so could result in serious injury.
Failure to do so could result in serious injury.
Remove the black rubber gasket from the air discharge plenum of the air conditioner (see fig. A). Look inside the wall sleeve and check to see if a black rubber gasket is already in place along the bottom front (see fig. B). If one is not in place, thoroughly clean the sleeve area between the front unit rests and the raised ledge (see fig. B). Once this area is clean and completely dry, peel the orange backing from the gasket and apply it to the base of the sleeve (see fig. B). Once the gasket has been properly applied, the sleeve is ready for the air conditioner to be installed per the installation instructons.
FIGURE A
AIR DISCHARGE PLENUM
FIGURE B
RAISED LEDGE
FRONT UNIT REST
SIDE PROFILE OF WALL SLEEVE
GASKET
49