INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
FORINTERNALDRAINL DRAINKIT (IDK)KIT (IDK)
Apply Sealer to the bottom of the Drain Plate
Wall Sleeve
Drill a .625” diameter hole here
Sleeve
Base
Dimple
0.5” In
from edge
4.75” From
Drill a .625” back of
diameter basepan hole in the
bottom of the basepan
WARNING
MECHANICAL HAZARD
MECHANICALCUT/SEVER HAZARD
Sharp edges and corners. Be careful with
Be careful with the sharp edges and corners. the sharp edges and corner. Wear protective Wear protective clothing and gloves, etc. clothing and gloves, etc.
Failure to do so could result in serious injury.
Failure to do so could result in serious injury.
1.DRILL A .625” DIAMETER HOLE IN THE BOTTOM OF THE SLEEVE BASE TO THE DIMENSIONS SHOWN.
2.APPLY A SILICONE TYPE OF SEALER TO THE OUTSIDE BOTTOM EDGES OF THE DRAIN PLATE.
3.INSERT THE DRAIN TUBE INTO THE HOLE AND PRESS THE DRAIN PLATE DOWN TO FORM A WATERTIGHT SEAL AGAINST THE SLEEVE BASE.
4.DRILL A .625” DIAMETER HOLE IN THE BOTTOM OF THE BASE PAN AS SHOWN IN THE ILLUSTRATION. THIS HOLE ALLOWS CONDENSATE TO ENTER THE WALL SLEEVE WHERE IT TRAVELS TO THE DRAIN KIT FOR DISPOSAL.
50