Craftsman 919.72412 owner manual How to Stop, Before Starting, Drain Valve, Check Valve

Page 14

Drain Valve: The drain valve is located at the base of the air tank and is used to drain condensation at the end of each use.

Drain

Valve

Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engineered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve: When the air compressor is operating, the check valve is "open", allowing compressed air to enter the air tank. When the air compressor reaches “cut-out" pressure, the check valve "closes", allowing air pressure to remain inside the air tank.

Check Valve

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off lever to "OFF".

Before Starting

Break-in Procedure

Serious damage may result if the

following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Auto/Off lever is in the "OFF" position.

NOTE: Pull coupler back until it clicks to prevent air from escaping through the quick connect.

2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

3.Open the drain valve fully (counter-clockwise) to permit air to escape and prevent air pressure build up in the air tank during the break-in period.

4.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.

5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

6.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

D24461

14- ENG

Image 14

Contents AIR Compressor Sold by Sears Canada, Inc. Toronto, Ont. M5B 2B8Table of Contents WarrantyImportant Safety Instructions Specification ChartSafety Guidelines Definitions Hazard Risk of Explosion or FireRisk of Bursting Risk from Flying ObjectsRisk of Electrical Shock Risk to BreathingRisk of Falling Risk of BurnsRisk from Moving Parts Risk of Unsafe Operation Glossary AccessoriesAccessories Duty CycleTools Required for Assembly AssemblyContents of Carton Installing Handles Wheels, and Molded Foot BumpersRisk of Electrical InstallationLocation of the Air Compressor Improper Grounding can Result in Electrical ShockExtension Cords Voltage and Circuit ProtectionDescription of Operation OperationKnow Your Air Compressor Drain Valve How to StopBefore Starting Check ValveHow to Start Before Each Start-UpCustomer Responsibilities MaintenanceTo Check Safety Valve To Drain TankOutlet Tube Nut Check Valve Service and AdjustmentsTo Replace or Clean Check Valve Screwdriver Open position nothing is visibleRegulator Arrow StorageTo Replace Regulator Troubleshooting Problem Cause CorrectionPressure reading Problem Cause Correction Pour Placer UNE Commande DE Pièces Garantie Complète DE UN AN SUR LES Compresseurs D’AIRConsignes DE Sécurité Importantes Tableau DES SpécificationsMesures DE Sécurité Définitions Risque D’EXPLOSION OU D’INCENDIE RisqueRisque D’ÉCLATEMENT Risque DE Projection D’OBJETSRisque DE Choc Électrique Risque PAR InhalationRisque DE Chute Risque DE BrûluresRisque Relié AUX Pièces Mobiles Risque Dune Utilisation Dangereuse Accessoires AccessoiresCycle DE Service LexiqueOutils requis pourlassemblage AssemblageContenu de la boîte Boulon à épaulementEmplacement du compresseur dair Directives DE Mise À LA TerreRallonges Protection contre la surtension et Protection du circuitDescription du fonctionnement UtilisationFamiliarisez-vous avec votre compresseur dair Interrupteur On/Auto/OffManostatAvant le démarrage Utilisation de lappareilArrêt de lappareil Avant chaque mise en marche Mise en marcheVérification de la soupape de sûreté EntretienResponsabilités du client Vidange du réservoirTube de sortie Écrou Remplacement ou nettoyage de la soupape de retenueEntretien ET Réglages TournevisRégulateur Flèche Remplacement du régulateurRangement Serrer DépannageProblème Cause Correction Peut éclater ou exploserConsidérée normale Fusible sauté ou coupe-circuit Remarque 51- FR D24461 Get it fixed, at your home or ours