Blue Sea Systems P12 user manual Supplies Needed, Socket wrench, Ring terminals

Supplies Needed	P12
	7521 AND 7522 BATTERY CHARGERS

1. AC Wire (see Table D page 5)

NOTE: Wire length must reach from the panel to the battery charger AC Connections with proper routing, support, drip loops, service loops, and termination.

2. DC Wire: Black or Yellow for negative and red for each positive. (see Table A page 5)

NOTE: Yellow is preferred for negative however diagrams are drawn in black for visibility.

3.Fuse holders for connection to each battery. (see Table B page 5)

4.Fuses for fuse holders. (see Table B page 5)

5.Screwdrivers

•Flat blade screwdriver

•Phillips #1 – for AC Termination cover and DC Termination Strain Relief clamp

•Phillips #2 – for AC termination screws

•Phillips #3 – for mounting screws

6.Socket wrench

•10mm socket with extension and ratchet handle or nut driver – for DC wire terminations

7.Ring terminals

•#8 ring terminals sized for AC/Supply wire gauge (quantity 3)

•¼” or M6 ring terminals sized for DC wire sizes (quantity 4)

8.Crimping tool or obtain wires that are pre-terminated

9.Appropriate heat shrink if pre-terminated wires were not acquired

8Specifications are subject to change. See bluesea.com/P12 for current information.