Xantrex Technology SW 3000 AC and DC Side Panels, Battery temperature sensor BTS jack provides

AC and DC Side Panels

The DC side of the Freedom SW 3000 has the equipment ground lug, the positive (+) battery terminal, and the negative (–) battery terminal plus the remote network com port and battery temperature sensor com port.

Freedom SW 3000 Inverter/Charger Features

Item Description

1	Remote (REM) jack provides connection for the
	Freedom Sine Wave remote panel (supplied).
2	Battery temperature sensor (BTS) jack provides
	connection for the battery temperature sensor (supplied).
3	Negative (–) DC terminal connects to the negative

1 2

REM BTS

3

WARNING: INCORRECT BATTERY OP AL TIR YW LIL

CAUSE DAMAGE TO UNIT.

5

INVERTER AC OUTPUT	LINE 1	AC INPUT
	LINE 2	AC INPUT

Wiring box cover must be in place during use to reduce risk of injury to persons

AC

IN

	battery cable (black). Install a DC terminal cover
	(supplied) over the terminal.
4	Positive (+) DC terminal connects to the positive battery
	cable (red). Install a DC terminal cover (supplied) over
	the terminal.
5	AC Input 1, AC Input 2, and Inverter AC Output
	circuit breaker switches allow you to reset the circuit
	breakers when they trip.
6	AC knockouts provide access for AC cables (both input

AC

OUT

AC GROUNDS

(BEHIND COVER)

4 9 8 7 6

Figure 5 AC and DC Side Panel

	and output wiring). Detach the knockout covers and
	install the strain-relief clamps (supplied).
7	AC Output terminal block is a screw-type terminal
	block for attaching AC output wires. Each slot is labeled
	N1 for Neutral 1, L1 and L2 for Lines 1 and 2, and N2 for
	Neutral 2.
8	AC Input terminal block is a screw-type terminal block
	for attaching AC input wires. Each slot is labeled
	N for Neutral and L1 and L2 for Lines 1 and 2.
9	Chassis ground lug connects the chassis of the FSW3000
	to your system’s chassis grounding point.

Not	All Ground terminals are along the tab at the bottom of
shown	the opening to the AC wiring compartment access panel.

975-0545-01-01 9