Operating The Freedom SW 3000
Operating in Charger Mode
EXPOSURE TO CHEMICALS AND GASES HAZARD
•Make sure the area around the battery is well ventilated.
•Make sure the voltage of the batteries matches the output voltage of the inverter/charger.
Failure to follow these instructions can result in death or serious injury.
NOTES:
•Study and follow all of the battery manufacturer's specific precautions, such as removing or not removing cell caps while charging, whether equalization is acceptable for your battery, and recommended rates of charge.
•For flooded
To operate the Freedom SW 3000 in charger mode from the front panel:
1.Connect AC input power.
The charger automatically starts up when qualified AC power is connected if the charger is enabled, or the charger is disabled but the Force Charge enable override is On. See “Force Charge” on page 23.
•The batteries are charged according to the
•You can interrupt the charge cycle any time you desire by disabling the charger from the SCP.
•To maintain optimal performance in flooded batteries, an occasional equalize cycle may be required. See “Operating in Equalization Mode” on page 18.
•While the batteries are being charged, you can monitor which stage they are in from the front panel of the Freedom SW 3000 or from the SCP.
2.To operate the charger with the SCP, refer to “Configuration” on page 25.
Charger Operation with Battery Temperature Sensor (BTS)
Since battery temperature is a key factor in correct charging, the charging formula must be adjusted (automatically and in real time) according to the actual battery temperature to ensure that batteries are fully charged, but not overcharged. For this reason, Xantrex has included a BTS (see Figure 6) with your Freedom SW 3000 Inverter/Charger and has temperature compensated the charge formula.
The BTS continuously measures the temperature of the battery and adjusts charger output for a more accurate,
17 |