Xantrex Technology 815-2524-02, 815-3524 manual Connecting the AC Output Wires, Equipment Damage

Connecting the AC Output Wires

EQUIPMENT DAMAGE

Do not connect the output of the inverter to any AC source.

Failure to follow these instructions can damage the unit and/or damage other equipment.

To make the AC output wiring connections:

1.Remove one of the AC knockouts from the front or side of the unit. Do not leave the knockout inside the wiring compartment.

IMPORTANT: The applicable installation code may not allow you to run the AC input and AC output wiring through the same AC knockout.

2.Install a strain-relief clamp in the AC knockout and run the AC wiring through the strain-relief clamp.

3.Strip approximately 50 mm off the jacket from the AC cable and separate the wires.

4.Using a 6 mm blade slot screwdriver, loosen the terminal screws on the AC output terminals. Do not remove the screws.

5.Connect the line and neutral wires to the output terminals (labeled AC Output on the terminal block, Figure 6 on page 25) as follows:

Connect Line to OUTPUT L, Neutral to OUTPUT N.

975-0697-01-01

	Installing the Inverter/Charger
6.	Tighten the terminal screws. Leave some slack wire inside the
	wiring box.
7.	Connect the ground wires to a free position on the ground bus,
	Figure 6 on page 25. If solid ground wire is being used, the wire	only.
	can be connected directly under the screw heads. If stranded
	ground wire is being used, ring terminals must also be used.	personnel
8.	Secure the strain-relief clamp on the AC output cable jacket.
9.	Attach the wiring compartment cover panel and tighten the four
	screws.	qualifiedbyuseforguideThis
10.	Connect the outgoing AC wires to an AC load panel equipped

with circuit breakers.

27