All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section B: The application example as demonstration
I t lli th h d | system |
d ft | |
Flying Saw with SIMOTION | |
6 Open Properties by |
|
the PG/PC(1). |
|
7Under the “Assignment” tab (this is already automatically selected), the ETHERNET interface used must be listed under “Assigned”. If this is already the case, then select this and set the checkmark for S7ONLINE access active.
In this case, you skip steps 8 and 9! Acknowledge your entry with OK.
Under certain circumstances, the Ethernet line of the PG/PC will have a ”yellow border”.
If the ETHERNET interface used is still not listed under “Assigned” then execute steps 8 and 9 (but only then!).
8The ETHERNET interface is still not “assigned”:
The configured interface of the control is listed under “Configured Interfaces” and all of the available interfaces of the PG/PC are under “Interface Parameter Assignments in the PG/PC”.
Select the ETHERNET interface to be used under “Interface Parameter Assignments in the PG/PC” (just the same as set in “Set PG/PC interface”) and press the Assign button.
If a warning is displayed, then acknowledge this with OK.
V 1.4 | Release 06/06/08 | 33/107 |