All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section B: The application example as demonstration system
|
|
|
|
|
O | t | t l f th | li ti | l |
Flying Saw with SIMOTION |
|
|
5.2.3Machine parameter settings
The standard application allows the following parameters to be adapted:
Machine geometry
•Distance to sensor
Distance between the flying saw axis and the sensor of the material and print mark detection
•StartPosition
Position from which the flying saw starts motion to achieve synchronism (with the material web)
•StartSyncPosition
Position at which the flying saw is synchronized, start of the synchronous traversing range
•EndSyncPosition
End of the synchronous traversing range
•EndPosition
Maximum traversing range of the flying saw
Flying Saw Axis Accelerations
•Cut
Acceleration value for synchronization
•Back
Acceleration value for return motion
•Gap
Acceleration value for creating a "gap".
Creating a "gap"
•GapVelocity
Additional velocity in order to create a gap between the material and the cut piece
V 1.4 | Release 06/06/08 | 51/107 |